Overview
The Crown Automotive Dana 44 JK Rubicon front driver side axle shaft, part number 68017180AB, replaces the factory Dana 44 front axle shaft on Jeep Wrangler JK models from 2007 to 2018. It is a direct fit for 2-door and 4-door models.
The assembly is made up of an inner shaft, an outer shaft and a U-joint, with 30 splines at the axle end. It sits in the front left position, the driver side of the vehicle. It suits a worn or damaged driver side shaft on a JK with a Dana 44 front axle.
Key features
- Front driver side axle shaft assembly for Dana 44 JK axles
- Inner shaft, outer shaft and U-joint in one assembly
- 30-spline axle end
- Direct fit for 2-door and 4-door models
Driver side shaft wear signs
An axle shaft carries drive torque from the carrier to the wheel, so wear shows up as vibration, clunks or noise when power is applied or released. The inner and outer shafts are joined by a U-joint, and a worn joint can produce a click on turns. Inspect the shaft as a whole, because a worn joint can stress the shaft and the hub bearing as well.
Replacing one driver side shaft is often done alongside a check of the opposite side, since both sides see similar load and age together. Before installing, confirm the spline count matches your current shaft and clean the mating surfaces at the hub. Use the service manual torque values for the axle nut and hub fasteners rather than estimates from memory.
- Clicking on tight turns can point to a worn U-joint
- Vibration under acceleration may indicate a bent or worn shaft
- Grease on the outside of the joint signals seal failure
- Inspect the opposite side at the same time
- Check the hub bearing for play once the shaft is off
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 68017180AB |
| UPC | 848399048094 |
| Axle type | Dana 44 JK |
| Axle manufacturer | Dana |
| Axle location | Front |
| Axle shaft location | Driver side assembly |
| Position | Front left |
| Axle spline | 30 splines |
| Fitment | Direct fit |
| Body styles | 2-door and 4-door |
| Components | Inner shaft, outer shaft, U-joint |
Vehicle fitment
The shaft is for the JK chassis, which covers 2007 to 2018 Jeep Wrangler JK models, including JKU versions with a Dana 44 front axle. Confirm fit for your vehicle’s year, model and trim before ordering.
This shaft is for JK applications, not Wrangler TJ, LJ or JL models, or Gladiator JT models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Replacing a front axle shaft means working at the hub and axle end, so check that the 30-spline count matches your current shaft before you start. Support the vehicle on jack stands rather than a jack alone.
What’s included
The assembly includes an inner shaft, an outer shaft and a U-joint.





