Overview
The Crown Automotive J8127070 is an AMC Model 20 rear driver side axle shaft, 26.25 inches long overall with 29 splines, for the 1976–1983 Jeep CJ5 and 1976–1981 CJ7 without Quadratrac. It is for the driver side of the AMC Model 20 rear axle in Narrow-Trac CJ models and fits vehicles without Quadratrac. Its position is rear left.
The overall length is 26.25 inches and there are 29 splines. It is a shaft alone rather than a kit. Separate numbers exist for CJ rear shafts depending on whether the Jeep has Quadratrac, a full-time four-wheel-drive system, and this one is for those without it. At 26.25 inches it is the shorter driver side shaft. CJ5 and CJ7 owners within the years above are covered, but the Scrambler is not. If you are unsure whether your CJ had Quadratrac, check before choosing. Anyone replacing both rear shafts needs this driver side shaft and its passenger side partner, J8127071, and should confirm the transfer case setup.
Key features
- Driver side rear axle shaft
- AMC Model 20 axle
- 26.25 inches overall length
- 29 splines
- For vehicles without Quadratrac
- Classed by Crown Automotive as a direct fit
Axle shaft wear and inspection
The rear axle shaft carries torque from the differential out to the wheel hub, so its splines and bearing take constant load. On a CJ, wear often shows up as a clunk when shifting from reverse into drive, a vibration under acceleration, or grease seeping from the axle flange. Check for play by rocking the wheel with the vehicle lifted safely. Cracked splines or a bent shaft need replacement rather than repair.
Shafts are usually replaced in matched pairs when mileage is high, because a new shaft beside a worn one can make the drivetrain feel uneven. Inspect the axle seal and wheel bearing at the same time, and confirm the transfer case setup if your Jeep has been modified. Keep the lug nuts torqued correctly after installation and re-check them after the first drive.
- Look for grease leaking from the axle flange
- Check the splines for wear or cracks
- Test the wheel for play with the vehicle safely lifted
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J8127070 |
| UPC | 848399068993 |
| Axle manufacturer | AMC |
| Shaft location | Driver Side |
| Axle position | Rear |
| Axle type | AMC 20 |
| Position | Rear Left |
| Spline count | 29 Splines |
| Overall length | 26.25 inches |
| Quadratrac | Without Quadratrac |
Vehicle fitment
This shaft fits two CJ models.
- 1976–1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade)
- 1976–1981 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Renegade)
The CJ5 is covered 1976–1983 and the CJ7 1976–1981, in non-Quadratrac form. The Scrambler and the YJ are not in this list. Confirm your vehicle’s year, model and trim before ordering.








