Overview
The Crown Automotive J8126614 is a 1310 drive shaft universal joint for the rear driveshaft at the rear axle. It fits the 1986 Jeep CJ7, including the Base, Laredo and Renegade trims.
The joint is 3-7/32 inch wide and carries the 1310 series designation. It is a direct-fit replacement and is lubeable, so it can be greased during service.
Key features
- 1310 series universal joint for the rear driveshaft
- Width of 3-7/32 inch
- Lubeable, so it can be greased
- Direct fit to the listed CJ7
Replacing a U-joint
A universal joint lets the driveshaft transmit power while the angle between shaft and axle changes with suspension travel. On a Jeep, worn joints usually show up as clunks when the drivetrain shifts from drive to coast, or as vibration that rises with speed. Because the cross and bearing caps wear together, many owners replace both joints on the same shaft when one fails.
Rear shaft joints are often serviced alongside the yoke and strap hardware, so inspect those parts while the shaft is out. Check that the cap bearings seat fully and that the retainers are secure before reassembling. Keep the joint greased if it has grease fittings, and look for seal leakage at each service.
- Look for play in the cross when rocking the shaft by hand
- Check yokes for wear or cracks
- Replace retaining clips during reassembly
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J8126614 |
| UPC | 848399068481 |
| U-joint series | 1310 |
| Width | 3-7/32 inch |
| Position | Rear driveshaft at rear axle |
| Lubeable | Yes |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1986 Jeep CJ7 in Base, Laredo and Renegade trims.
The list does not include the 1981–1985 CJ7 years or the CJ5. Confirm your vehicle’s year, model and trim before ordering.
What’s included
It is a single universal joint. Check the package contents against your installation before starting.









