Overview
The Bilstein 47-310049 is a B8 6112 front leveling kit with a 2.5-inch front lift for the 2000–2006 Toyota Tundra and the 2001–2007 Toyota Sequoia. The kit uses coilover shocks in the front and lifts the front only, so the rear stays where it is. It has a zinc plated finish.
The B8 6112 kits give more ground clearance, room for larger tires and more wheel travel. This kit uses two 60mm shock absorbers, two matched coil springs and two billet aluminum spring seats. The digressive piston provides damping control, and the spring seat sits in the snap-ring grooves. There are no bump stops and no track bar drop, so the track bar stays at its factory height after the front is raised. The zinc plated finish is designed for durability.
Key features
- 2.5 inches of front lift
- Front coilover shock design
- Zinc plated finish
- Two 60mm shock absorbers with a digressive piston
- Matched cold wound coil springs and billet aluminum spring seats
Zinc finish and ongoing care
A zinc plated finish gives the exposed metal a sacrificial layer that helps slow corrosion on the shock body and hardware. Road salt, mud and water are the main sources of rust on front suspension parts, so rinsing the components after wet or salty drives helps preserve the finish. Scratches that reach bare metal are worth touching up before rust can spread.
Regular inspection matters more than the finish alone. Check the shock mounts, spring seats and bolts for looseness, and look for leaks around the shock seals. Because the front is raised, the tires and brake lines should also be checked for rubbing or stretching after the first drives.
- Rinse the front suspension after salty drives
- Touch up scratches that reach bare metal
- Check shock mounts and spring seats for looseness
- Look for leaks around the shock seals
Specifications
| Brand | Bilstein |
|---|---|
| Part number | BIL47-310049 |
| Series | B8 6112 |
| Front lift | 2.5 inches |
| Rear lift | Not applicable, front lift only |
| Front lift method | Coilover shocks |
| Finish | Zinc plated |
| Track bar drop | Not included |
| Bump stops | None |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2001–2007 Toyota Sequoia, including the Limited and SR5 trims, and the 2000–2006 Toyota Tundra, including the Base, Limited and SR5 trims.
The list does not cover the Tundra from 2007 onward or the Sequoia from 2000 or 2008. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The track bar drop is not included, so the track bar stays at its factory height. Check the alignment after installation.
What’s included
Two 60mm shock absorbers, two matched coil springs and two billet aluminum spring seats.
Not included: Track bar drop.









