Overview
The Bilstein 33-187501 is a rear 5100 Series gas-charged shock absorber that the manufacturer fitment list places on the 2009–2013 Ford F-150. It has a monotube body with high gas pressure, a 46mm smooth non-coilover housing, 12mm eye mounts and a 14mm shaft.
The 5100 Series is designed for specific lift kits that keep the stock O.E.M. mounting configuration, with a 0 to 1 in. lift range for this rear unit. Its single-tube design is built for fade-free damping and long service life.
Key features
- Monotube gas pressure construction with consistent damping
- Self-adjusting deflecting disc valving
- High-flow piston that Bilstein says reduces harshness
- Independent rebound and compression tuning
- Larger working piston area for controlled damping
- Boot included
Rear shock service and handling
A rear gas shock is a sealed unit, so most of its service life depends on the condition of the body, seals and mounts rather than on internal adjustment. Keeping the eye mounts tight and the boot intact protects the shaft from grit, which is the most common route to seal damage on a pickup.
Gas-charged monotube shocks respond well to steady use, but hard impacts from potholes or trail obstacles can stress the body and bushings. After rough driving, look at the shaft for scoring and check the body for oil film. If the truck feels bouncy after a shock change, check the rear springs and bushings too, since a shock works as part of the whole system.
Clean the shaft and boot when you wash the truck, and avoid high-pressure spray directly at the seals.
- Keep eye mounts and bolts tight
- Inspect the boot for cuts and dirt
- Look for scoring on the exposed shaft
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 33-187501 |
| UPC | 651860642680 |
| Shock series | 5100 Series |
| Position | Rear |
| Fitment | Direct Fit |
| Lift height | w/0 – 1 in. lift |
| Collapsed length | 17.68 in. |
| Extended length | 28.9 in. |
| Travel length | 11.22 in. |
| Lower mount | Eye 12mm |
| Upper mount | Eye 12mm |
| Shaft diameter | 14mm |
| Body design | 46mm ID smooth body (non-coilover) |
| Internal design | Mono tube |
| Reservoir | No |
| Boot included | Yes |
| Finish | Zinc plated |
| Hydraulic / gas charged | Gas charged |
Vehicle fitment
It fits the 2009–2013 Ford F-150 in the FX4, Harley-Davidson Edition, King Ranch, Lariat, Lariat Limited, Limited, Platinum, STX, XL and XLT trims. It is a Direct Fit with a 0 to 1 in. lift range.
Years outside 2009–2013 are not covered by this list, and this unit is for the rear position only. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check the 12mm eye mounts and rear hardware against your vehicle before fitting. Gas shocks are under pressure, so do not open, drill or heat the body.
What’s included
One rear 5100 Series shock absorber with boot included. Check the package contents, including mounting hardware, against your installation before starting.









