Overview
The Bilstein 5100 Series Shock Absorber, part number 24-186742, is a monotube gas pressure shock absorber with a 46mm smooth body and 14mm eye mounts at both ends. Bilstein markets the 5100 Series for lifted trucks, Jeeps and prerunners, and the manufacturer fitment list names Chevrolet Silverado and GMC Sierra models from 1999 to 2010.
Bilstein describes single tube high gas pressure construction as the basis for consistent, fade-free performance and long life. The shock uses self-adjusting deflecting disc valving and a high-flow piston that Bilstein says reduces harshness, along with a larger working piston area for damping control.
Bilstein also presents the 5100 Series as offering control for large diameter tires and as designed for specific manufacturer lift kits that keep the stock O.E.M. mounting configuration. Collapsed length is 16.14 in, extended length is 26.15 in and travel length is 10.01 in, so the travel can be compared with your lift height before ordering.
Key features
- Monotube gas pressure construction in a single tube body
- Self-adjusting deflecting disc valving
- High-flow piston that Bilstein says reduces harshness
- Independent rebound and compression tuning
- Larger working piston area for exact damping
- Built for specific manufacturer lift kits that use the stock O.E.M. mounting layout
- Boot included
Lift kit compatibility
A shock designed for a specific lift kit depends on that kit’s geometry. The stock O.E.M. mounting layout means the upper and lower mount positions match the kit’s brackets, so a mismatch can leave the shock bottoming out or binding. Before buying, compare the collapsed and extended lengths with the height your truck runs, and confirm the spring and bump stop setup is compatible.
Trucks that run larger tires or heavier bumpers add load to the shock mounts, so inspect the eye bushings and bolts before installing. Lift kits often change the angles of the control arms and driveshaft, which can change how the shock moves through its travel. If the ride feels harsh or the front end hops after the install, recheck the mounting and angle before assuming the shock is faulty.
- Verify the mounting layout matches your kit
- Measure installed length against your ride height
- Check bushings and bolts for wear
- Re-check bolts after the first few drives
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 24-186742 |
| UPC | 651860565484 |
| Series | 5100 Series |
| Internal design | Mono tube |
| Charge | Gas charged |
| Body design | 46mm ID smooth body (non-coilover) |
| Collapsed length | 16.14 in |
| Extended length | 26.15 in |
| Travel length | 10.01 in |
| Lower mount | Eye 14.12mm |
| Upper mount | Eye 14.12mm |
| Shaft diameter | 14mm |
| Finish | Zinc plated |
| Reservoir | No |
| Boot included | Yes |
Vehicle fitment
The manufacturer fitment list covers 1999–2010 Chevrolet Silverado and GMC Sierra trucks in 1500, 1500 HD, 2500, 2500 HD, 3500 and 3500 HD configurations, plus 2007 Classic models in those lines. Several entries name only certain trims, such as LT or SLE, so each year and trim pairing matters.
Models from 2011 onward, other makes and Jeep models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Bilstein designs this shock for specific manufacturer lift kits, so confirm that your lift kit uses the stock O.E.M. mounting layout before installing. Both eye mounts are listed at 14.12mm, so check the mounting hardware on your truck against those dimensions.
What’s included
A Bilstein 5100 Series shock absorber with boot.
Not included: Check mounting hardware and lift kit parts against your truck before starting the installation.









