Overview
The Bilstein 5100 Series shock absorber, part 33-185552, is a rear shock for lifted trucks, Jeeps and prerunners, with a 46mm smooth body and zinc plated finish. It has a 4 in. lift rating and fits the 1961-1983 Toyota Land Cruiser in Base trim. It is designed for lift kits that keep the stock OEM mounting configuration.
The 5100 Series uses traditional Bilstein monotube gas pressure construction, which Bilstein says delivers consistent fade-free performance and long life. Its single tube design has self-adjusting deflecting disc valving and a high-flow piston that Bilstein says reduces harshness on rough ground.
Key features
- Monotube gas pressure construction
- Self-adjusting deflecting disc valving
- High-flow piston intended to reduce harshness
- Independent rebound and compression tuning
- Larger working piston area for exact damping
- Superior control for large diameter tires
- Designed for manufacturer lift kits that use the stock OEM mounting
Mounts and lift kit fit
A rear shock on a lifted Land Cruiser carries a lot of the axle’s movement, so the mounting points matter as much as the damping. Eye mounts at each end pivot on bushings or pins, and the wear on those bushings and the pin fit should be checked before a new shock goes on. Compare the shaft and eye sizes with your existing hardware rather than relying on memory.
A lift kit changes the geometry of the axle and the angle of the shock, which can reduce available travel or push the shock out of its designed range. Look for bottoming, binding at full extension, or a boot that is stretched or rubbing. Re-check the mounts after the first few trail runs, and tighten any hardware that has loosened under vibration.
- Check eye mount bushings for wear
- Inspect the boot for tears or rubbing
- Re-torque hardware after the first trail runs
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 33-185552 |
| UPC | 651860453705 |
| Shock series | 5100 Series |
| Position | Rear |
| Reservoir | None |
| Internal design | Monotube |
| Body design | 46mm ID smooth body, non-coilover |
| Shaft diameter | 14mm |
| Lower mount | Eye, 16mm |
| Upper mount | Eye, 16mm |
| Collapsed length | 15.91 in. |
| Extended length | 25.93 in. |
| Travel length | 10.02 in. |
| Finish | Zinc plated |
| Boot included | Yes |
| Charging | Gas charged |
| Lift height | w/4 in. lift |
| Fitment | Direct fit |
Vehicle fitment
It is a direct fit for the stock mounting configuration on the 1961-1983 Toyota Land Cruiser in Base trim.
Other Toyota models and Land Cruiser years outside 1961-1983 are not covered here. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Confirm the lift kit on your truck matches the shock’s mounting before you install, since Bilstein designs this model around specific manufacturer kits. Both eye mounts are 16mm and the shaft is 14mm, so compare these with your existing hardware before you start.
What’s included
A boot is included with the shock absorber. This is a single rear shock with no reservoir.









