Overview
The Bilstein 33-151618 is a 5100 Series monotube gas pressure shock absorber that fits the 1993-1998 Jeep Grand Cherokee (ZJ) and the 1993 Jeep Grand Wagoneer (SJ). It has a collapsed length of 15.91 in, an extended length of 25.93 in and 10.02 in of travel.
The 5100 Series suits lifted trucks, Jeeps and prerunners. It is designed for specific lift kits that use the stock O.E.M. mounting configuration. The shock has a 46mm ID smooth body, a zinc plated finish and no reservoir.
Key features
- Monotube gas pressure construction
- Self-adjusting deflecting disc valving
- High-flow piston that Bilstein says reduces harshness
- Independent rebound and compression tuning
- Larger working piston area for exact damping
- Designed for control with large diameter tires
- Uses the stock O.E.M. mounting configuration
- Zinc plated finish
Choosing the right setup
The ZJ Grand Cherokee and Grand Wagoneer carry a fair amount of weight, and both the front and rear shocks handle much of the work of keeping the body controlled over rough roads and when towing. Gas pressure helps the shock keep damping steady during repeated hard compression, which matters on trails and long grades. Compare your driving with the valving design before choosing.
Large tires add weight and change the leverage on each shock, so a shock designed for control with larger tires can be a sensible match. When the new shock is installed, check that the brake line and body have clearance through full travel, and make sure the bushings and sleeves sit square to avoid binding.
- Check the bushings and sleeves for cracks before fitting
- Match left and right shocks on each axle when replacing
- Inspect the front and rear mounts for play while the shock is off
- Re-check the mounting bolts after the first drive
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 33-151618 |
| UPC | 651860604633 |
| Product type | Shock absorber, 5100 Series |
| Design | Monotube, gas pressure |
| Collapsed length | 15.91 in |
| Extended length | 25.93 in |
| Travel | 10.02 in |
| Lower mount | Eye, 12mm |
| Upper mount | Eye, 16mm |
| Shaft diameter | 14mm |
| Body | 46mm ID smooth body |
| Reservoir | No |
| Finish | Zinc plated |
| Fit type | Direct fit |
Vehicle fitment
It fits the 1993-1998 Jeep Grand Cherokee (ZJ) in the 5.9 Limited, Base, Laredo, Limited, Orvis, SE and TSi trims, and the 1993 Jeep Grand Wagoneer (SJ) Base.
It fits the ZJ Grand Cherokee for 1993-1998 and the 1993 Grand Wagoneer. Confirm front or rear placement and your vehicle’s year, model and trim before ordering.
Installation notes
Replacing a shock is a straightforward job with basic hand tools once the vehicle is supported on rated jack stands. Fit the supplied bushings and sleeves in the correct order, and tighten the mounting bolts with the suspension at ride height. Check that the shock does not limit travel or contact the brake line.









