Overview
The Bilstein 24-186940 is a 5100 Series ride height adjustable front shock absorber for 2007–2014 Chevrolet and GMC trucks and SUVs, including the Avalanche, Silverado 1500, Suburban 1500, Tahoe, Sierra 1500, Yukon and Yukon XL 1500. It installs like a factory replacement shock and corrects the nose-down rake that many of these vehicles have from the factory.
The shock levels the front to rear ride height by repositioning the factory spring seat, which adds preload to the factory spring. The snap ring grooves on the body allow up to 2.75 in of front end lift depending on application, and the added wheel travel accommodates a 33-inch tire. It is a practical alternative to strut extension or spring pre-load spacer kits.
Key features
- Corrects factory nose-down rake for a level front-to-rear ride height
- Repositioned spring seat adds preload to the factory spring
- Snap ring grooves allow up to 2.75 in of front end lift, depending on application
- Monotube gas pressure construction
- Added wheel travel for a 33-inch tire
- Application-specific designs are offered for many popular light trucks and SUVs
Setting up ride height
A ride height adjustable shock changes how the front suspension sits, so before and after measurements matter. Measure the front wheel well to ground distance on both sides before removing the old shock, then recheck once the new unit is installed. Small differences from side to side can cause pulling or uneven tire wear, which is why careful measuring is worth the time.
Front alignment will usually need checking after a ride height change, and tire clearance should be confirmed with the wheels and tires you plan to run. Look at the bump stops, sway bar links and brake lines for contact during full compression and full extension. Keep the dust boot in place after installation, since the boot is not included with this shock.
- Measure both sides before and after
- Confirm tire clearance at full lock
- Check brake lines and sway bar links
- Schedule a front alignment check
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 24-186940 |
| UPC | 651860640167 |
| Shock series | 5100 Series, ride height adjustable |
| Position | Front |
| Fitment type | Direct fit |
| Lift range | 0 to 1.75 in |
| Collapsed length | 12.95 in |
| Extended length | 18.48 in |
| Travel length | 5.53 in |
| Lower mount | Bar pin |
| Upper mount | Stem |
| Shaft diameter | 14mm |
| Body design | 46mm ID snap ring grooved body (coilover) |
| Internal design | Monotube |
| Reservoir | No |
| Gas charge | Gas charged |
| Finish | Zinc plated |
| Boot | Not included |
Vehicle fitment
The manufacturer fitment list covers 2007–2013 Chevrolet Avalanche, 2007–2013 Chevrolet Silverado 1500, 2007–2014 Chevrolet Suburban 1500 and Tahoe, 2007–2013 GMC Sierra 1500, and 2007–2014 GMC Yukon and Yukon XL 1500. Trims in the list include LS, LT, LTZ, Z71, SLE, SLT, Black Diamond, Hybrid and WT.
The list does not include Silverado or Sierra 2500 HD and 3500 models, and model years outside 2007 through 2014 are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The spring seat is repositioned during installation, so have the front alignment checked afterward because ride height changes. Lift results depend on the application, so check the finished height before driving at highway speed.
What’s included
One Bilstein 5100 Series shock absorber, part 24-186940, with the factory-style mounting design described above. Not included: the dust boot.









