Overview
The Bilstein 5100 Series Shock Absorber, part number 24-249928, is a front gas-charged shock for the 1996–2004 Toyota Tacoma. The 5100 Series is Bilstein’s single tube, high gas pressure line, and Bilstein names lifted trucks, Jeeps and prerunners as its target applications.
The monotube design is built for consistent, fade-free performance and long service life. The shock is made for specific lift kits and keeps the original OE mounting configuration. The lift range is 0 to 2 in., and the Tacoma trims that fit are shown below.
Key features
- Monotube gas pressure construction for consistent, fade-free performance
- Self-adjusting deflecting disc valving
- High-flow piston intended to reduce harshness
- Independent rebound and compression tuning
- Larger working piston area for more exact damping
- Built for larger diameter tires.
- Designed for specific manufacturer lift kits that use the original OE mounting configuration
Lift kits and mounting
Lift kits change the geometry of the front suspension, so the shock must be matched to the height and mounting points the kit creates. A shock that is too short or too long can bind, bottom out or reduce travel. Shocks built for specific lift kits keep the original mounting configuration, which simplifies installation.
Tacoma owners who run larger tires often notice more load on the front dampers, so inspecting the mounts and bushings during each service is a good habit. Replace shocks in pairs on the same axle, and check the boot and seals for oil leaks after the first few drives.
- Confirm lift kit compatibility before ordering
- Check upper and lower mounts for wear
- Inspect for oil seepage at the body
- Look for uneven front tire wear
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 24-249928 |
| UPC | 651860764580 |
| Product line | 5100 Series |
| Position | Front |
| Fitment type | Direct Fit |
| Lift height | 0-2 in. lift |
| Construction | Gas charged, monotube |
Vehicle fitment
Fits the 1996–2004 Toyota Tacoma in Base, Limited, Pre Runner, S-Runner and SR5 trims.
Tacoma model years after 2004 and other Toyota models are not on this list, and trims not named are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
It is designed for specific lift kits that keep the original OE mounting configuration. Check that your lift uses the original OE mounting points before installing.
What’s included
One front shock absorber. No other parts are named.









