Overview
The Bilstein 4600 Series front shock absorber, part number 24-064606, is a yellow monotube gas-charged shock with a 2 in. body. It is a front position unit with no reservoir and a 0 in. lift/drop rating, and it is a direct fit for the 1998–2003 Dodge Dakota.
The monotube design moves heat from the oil out through the shock body, and a dividing piston lets the oil expand as it warms. This helps the shock keep its full damping as temperatures rise, which matters on long drives or on trails. The tube is extruded to a tight peak-to-valley tolerance for consistent wall thickness, and the design uses fewer parts than many twin tube shocks.
Key features
- Gas-charged monotube design with a 2 in. body
- Dividing piston reduces aeration (foaming) and viscosity loss in the oil
- Extruded tube with tight peak-to-valley tolerance
- Piston head tunes compression and rebound damping independently
- Fewer parts than most conventional twin tube designs.
- Direct fit listing for the Dakota trims named below
- Yellow finish
Heat and long drives
Shocks turn motion into heat, and the damping oil is the part that suffers when it gets hot. A monotube design that moves heat through the body helps the oil hold its damping feel over long highway runs, steep grades and slow crawls where the shock works continuously. On a Dakota, that consistency is most noticeable when towing or carrying a load over rough roads.
If the front shocks are already worn, the front end may wander, dive under braking, or pound over washboard. Shocks are usually replaced in pairs on the same axle. When fitting new units, check that the upper and lower mounts seat square and that the bump stops are not split or missing, since those parts keep the travel under control.
- Check bushings at both mounts
- Inspect bump stops for cracks
- Look for fluid on the body after a hard drive
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 24-064606 |
| UPC | 651860455150 |
| Series | 4600 Series |
| Position | Front |
| Body diameter | 2 in. |
| Type | Monotube |
| Charge | Gas charged |
| Finish | Yellow |
| Reservoir | No |
| Boots included | No |
| Lift height | 0 in. lift/drop |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1998–2003 Dodge Dakota in Base, R/T, SLT, SXT and Sport trims. Dakota years outside that range, along with the Durango and Ram lines, are not covered.
The 1997 model year and 2004 and later Dakota years are not covered by the list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One front Bilstein 4600 Series shock absorber.
Not included: boots. The specifications list boots as not included, so a boot is a separate part.









