Overview
The Baer Brakes 6929494 is a right-side replacement brake rotor measuring 13.000 inch in outside diameter, made for certain Baer Track4, SS4 and other Baer brake systems. It is a 1-piece, vented rotor in cast iron with a tall hat and a plain finish.
The rotor is directional and made for one side of the vehicle, so this version is the right-hand part for the axle it is matched to. A replacement rotor is the disc the brake pads clamp against, so its diameter, thickness and bolt pattern must match the existing hub. Confirm fit for your vehicle’s year, model and trim before ordering.
Key features
- Full cast, one-piece construction in cast iron
- Curved vane design intended to help cooling
- Dynamic balanced for smooth, vibration-free running
- Designed for rotor stability and resistance to distortion
- Directional brake surface made for the right side only
- Tall hat with a 6.410 inch hat ID
- Plain surface finish with performance grade casting
Before you buy
Brake rotors wear from pad contact, heat cycles and rust, so a replacement is usually fitted when the friction face is worn below its usable thickness or shows deep grooves, pulsation under braking, or heat checking. Inspect the hat and hub face for corrosion before mounting, and clean the mating surfaces so the rotor sits flat against the hub.
A rotor is best changed as part of a set. Pads, caliper bracket and wheel bearings are worth checking at the same time, since worn parts can shorten the life of a new rotor. A tall hat leaves room for the caliper, but true running depends on the register and hub face, so measure those against the hub before fitting.
- Measure the existing rotor thickness against its minimum
- Check hub face runout with a dial indicator before fitting
- Replace pads together with the rotor for even bedding
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6929494 |
| UPC | 90127962473 |
| Outside diameter | 13.000 inch |
| Nominal thickness | 1.100 inch |
| Overall height | 2.232 |
| Stud/lug hole circle diameter | 5.00 inch |
| Stud/lug hole quantity | 5 |
| Center hole diameter | 3.089 |
| Register | 2.781 inch |
| Hat ID | 6.410 inch |
| Axle | Right |
| Construction | Full cast, one piece |
| Rotor type | Vented |
| Brake surface | Directional |
| Surface type | Plain |
| Material | Cast iron |
| Grade type | Performance |
| Drum in hat | No |
| ABS tone ring included | No |
| Emission code | 6 |
| Export description | Brake components |
| Country of origin | USA |
| Sold as | Each |
Vehicle fitment
It is made for certain Baer Track4, SS4 and other select Baer brake systems. Confirm which system and axle it matches before choosing it.
Confirm your vehicle’s year, model and trim before ordering. This rotor is for the right side only.
Installation notes
Because the rotor is directional and side-specific, confirm the side before mounting. Compare the 3.089 center hole and 6.410 inch hat ID with the hub you are replacing, and check the 5.00 inch bolt circle against the existing studs. Brake work is safety-critical, so pads, caliper and bedding should follow the instructions supplied with those parts.
What’s included
One Baer Brakes replacement rotor, supplied as each.
Not included: brake pads, caliper and mounting hardware.
