Overview
The Baer Brakes 6929106 is a 13 inch right-side replacement brake rotor with a plain surface, made for certain Baer Track4, SS4 and other Baer Brake systems. It is a one-piece, full cast vented disc, the part many people call a brake rotor.
A plain face without slots or drilled holes suits drivers who want a basic cast disc for the right side of a compatible Baer system. Because the disc is directional, install it on the side it is built for. Confirm fit for your vehicle’s year, model and trim before ordering.
Key features
- Curved vane pattern aimed at cooling.
- Purpose built, full cast construction from premium materials.
- Design focused on stability and resisting distortion.
- Factory dynamic balancing for smooth running.
- Plain surface, with no slots or drilling noted.
- Vented directional cast iron body, performance grade.
Pads and calipers to match
A plain rotor leaves the pad contact surface unbroken, so it depends on a good pad compound and clean, even contact to brake well. Pad choice matters: a soft compound may wear quickly on a cast iron disc, while a harder compound can run cooler but grab less when cold. Match the pad to how you drive, whether on pavement, on trails, or both.
Calipers should be inspected at the same time as the rotor. Look for sticking slides, torn boots and uneven pad wear, since a seized caliper can overheat one rotor even when the replacement is correct. Clean the hub face and remove rust before bolting the rotor on, and check that the rotor sits flat against the hub.
- Replace pads when the friction material is worn thin
- Check brake fluid condition during rotor service
- Use new hardware and clips with new pads
- Inspect the hub for rust that could affect seating
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6929106 |
| UPC | 90127962275 |
| Axle side | Right |
| Outside diameter | 13 in |
| Nominal thickness | 1.1 in |
| Overall height | 2.232 in |
| Center hole diameter | 2.781 in |
| Stud/lug hole circle diameter | 4.50 in and 4.75 in |
| Stud/lug hole quantity | 5 |
| Construction | Full cast, one piece |
| Material | Cast iron |
| Rotor type | Vented |
| Brake surface | Directional |
| Surface type | Plain |
| Hat | Tall hat, no drum in hat |
| ABS tone ring included | No |
| Grade type | Performance |
| Emission code | 6 |
| Country of origin | USA |
| Sold as | Each |
Vehicle fitment
It is made for certain Baer Track4, SS4 and other Baer Brake systems rather than a specific year, make and model.
Confirm your vehicle’s year, model and trim before ordering. Measure your hub’s bolt circle and center bore against the figures in the table above.
Installation notes
Keep the right-side orientation and the vane direction correct when fitting. Each rotor is sold alone, so a matching left-side disc is a separate part. Have a professional mechanic handle the hub and brake work.
What’s included
A single right-side rotor, sold as each.
Not included: ABS tone ring, pads and calipers.
