Overview
The Auburn Gear 542097 is a limited slip differential assembly for GM 10 bolt axles with 30 splines. It fits the 8.6 inch GM 10 bolt and the 8.5 inch GM 10 bolt, in rear or front axle location. The H/P Series uses a preloaded tapered cone type clutch system for smooth, streetable driving on and off road.
The unit includes a no questions asked 4 year replacement D-REX program. Confirm fit by axle type and 30 spline count, and check your vehicle’s year, model and trim before ordering.
Key features
- Limited slip assembly with preloaded tapered cone type clutch
- Smooth, streetable operation described by the manufacturer
- GM 10 Bolt 8.6 Inch and 8.5 Inch axle types named
- Rear or front axle location
- 30 spline axle count
- 4 year replacement D-REX program
Carrier and ring gear match
A limited slip unit has to suit the carrier and ring gear already in the housing, so the match is checked before the install starts. Backlash, gear ratio and carrier size all affect how the clutch loads the gears. A mismatch can lead to noise, heat and early wear, so measuring first avoids a second teardown.
The H/P Series clutch works with steady torque and benefits from a careful break-in. Expect a short adjustment period as the plates seat, and keep the gear oil topped up. When the unit is installed in a GM 10 bolt housing, the carrier bearings and pinion seal are usually replaced at the same time, since the housing is open anyway.
- Measure the housing width before ordering
- Check ring gear and pinion ratio
- Replace pinion seal and carrier bearings during the job
Specifications
| Brand | Auburn Gear |
|---|---|
| Part number | 542097 |
| UPC | 81499600097 |
| Differential type | Limited slip assembly |
| Clutch system | Preloaded tapered cone type |
| Axle manufacturer | GM |
| Axle type | GM 10 Bolt 8.6 Inches or GM 10 Bolt 8.5 Inches |
| Axle location | Rear or front |
| Axle spline | 30 splines |
| Program | 4 year replacement D-REX program |
Vehicle fitment
Fit is by axle type: GM 10 bolt 8.6 inch and 8.5 inch axles with 30 splines. Measure your axle and check the spline count before fitting.
Housings outside the 8.6 and 8.5 inch GM 10 bolt types are not a match for this unit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Match the carrier and ring gear to this assembly before installation, because a limited slip unit must suit the existing gears. Allow a break-in period before hard use, and have an axle shop set backlash and preload.
What’s included
The unit is a limited slip differential assembly. Check the box contents against your installation before fitting.










