Overview
The Auburn Gear 545020 is an ECTED Max selectable locker for the front Dana 50 axle with 30 splines. It pairs a full-time limited slip with a full locking differential, engaged by an in-vehicle switch. The change can be made on the fly at moderate speeds.
The unit fits front axle location only. Check the Dana 50 housing and spline count against your axle before fitting.
Key features
- Full-time limited slip operation
- Full locking mode engaged from inside the vehicle
- Changes can be made on the fly at moderate speeds.
- 30 spline axle count
- Front axle location
Planning the install
The Dana 50 is a heavy front axle, and a selectable locker suits builds that need more traction on loose or steep ground. Because the locker sits inside the carrier, shops usually inspect gears, bearings and seals at the same time. Confirm the housing and spline count match before ordering, since a mismatch can stop the unit from going in.
Front lockers change how the truck pulls through turns, so think about how often you will use full lock and how the switch fits your cab. Check the wiring route and clearance around the steering components. Keep the fluid clean and watch for leaks, since the clutch relies on good lubrication.
- Check housing type and spline count
- Inspect carrier bearings during install
- Plan the switch location before the install starts
Specifications
| Brand | Auburn Gear |
|---|---|
| Part number | 545020 |
| Differential type | Selectable locker (ECTED Max) |
| Locking mode | Full lock via in-vehicle switch |
| Axle manufacturer | Dana |
| Axle type | Dana 50 |
| Axle location | Front |
| Axle spline | 30 splines |
Vehicle fitment
It fits a front Dana 50 axle with 30 splines. Confirm fit for your vehicle’s year, model and trim before ordering.
Only the Dana 50 axle type is named, so other Dana axle families are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A selectable locker needs an in-vehicle switch and its wiring, and that work is best done by a qualified installer. Gear setup and bearing preload must match the carrier, and the clutch should be broken in before heavy use.
What’s included
Check the switch, wiring and hardware contents against your installation before starting.










