Overview
The Artec JK4411 is a front axle armor kit for the Dana 44 front axle on the 2007-2018 Jeep Wrangler JK. Artec Industries designed this truss system and armor to reinforce both axle tubes, not just the long tube, and to take serious abuse off-road.
The kit uses 1/4-inch thick truss top material and 10 gauge gussets. It suits builds that include a lift, since the track bar bracket choice depends on how the lift mounts. The parts are precision cut and formed for a straightforward installation.
Key features
- Heavy duty truss and armor design that Artec describes as light weight
- 1/4-inch thick truss top and 10 gauge gussets
- Gusseting strengthens both axle tubes, not just the long tube
- Precision cut and formed components
- Front lower control arm skids included
- Heavy duty stock height track bar bracket included, with a raised height option sold separately
Before you weld
Front axle armor is usually chosen to protect the housing and the tubes from rocks, stumps and hard landings. Because a truss ties both axle tubes together, it spreads impact loads across the axle instead of leaving one tube to take the hit. That matters most on a Dana 44 with large tires, where the axle sees steady loading and occasional sharp shocks.
Before welding, clean the axle and mark the bracket locations, then check clearance around brake lines, the differential cover and the steering components. Plan the weld sequence so heat is spread out and the housing does not warp. If welding is not your strength, have a shop with axle experience do the fabrication. Recheck alignment and bolt torque after the first few trail runs.
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | A/IJK4411 |
| UPC | 816791021762 |
| Type | Axle armor kit |
| Axle | Dana 44 front |
| Truss top thickness | 1/4 inch |
| Gusset gauge | 10 gauge |
| Tube diameter | Any |
| Quantity | Single |
Vehicle fitment
It fits the front Dana 44 axle on 2007-2018 Jeep Wrangler JK models (JK chassis code).
It is made for the front Dana 44 axle, not the rear axle. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
This kit requires welding and general fabrication. Some grinding and fitment may be required because every axle varies slightly. Choose the bracket that matches your lift: the factory height bracket if your lift replaces the track bar, also called a tracbar, and mounts to the factory axle bracket, which is typical with an adjustable track bar lift; or the raised height kit A/IJK4410 for a drag link flip, which requires a minimum 3-inch lift and bumpstop extensions.
Welding and grinding on axle components call for experienced fabrication work.
What’s included
Front axle truss, front lower control arm skids, inner C gussets, and a heavy duty stock height track bar bracket.
Not included: the raised height track bar bracket kit A/IJK4410, which is needed for drag link flip setups with a minimum 3-inch lift.












