Overview
The Artec RM6007 is a DIY ram mount for Dana 60 axles and 9 inch housings. It holds a double-ended hydraulic steering ram close to the axle centerline and protects it with an integrated 1/4 inch thick skidplate. It is designed for PSC motorsports and Howe Performance double-ended hydraulic rams, so it suits builders who want hydraulic steering on a shortened Dana 60 or a 9 inch axle.
Because the kit is DIY, you cut out a section to clear the third member, and the fit after modification is the builder’s responsibility. The mount runs end to end along the axle tube, and its gusseting reinforces the ram mount against impact. The design pairs with Ultimate Dana 60 High Steer Arms, and reinforcing the area around the cutout is advised when it is close to or overlaps the speed holes.
The axle tube diameter is 3.125 inch as designed, and the mount can be modified for other sizes. Check the dimensions against your axle before cutting anything.
Key features
- Integrated 1/4″ thick skidplate protects the ram from rocks
- Mount runs the full length of the axle tube to reinforce it against bending and shearing
- Gusseting reinforces the ram mount against damage from impact
- Designed for PSC motorsports and Howe Performance double-ended hydraulic rams
- Bolt-on differential skid with hardware included
- Cut-to-fit design: the third member clearance is made by cutting the mount
Hydraulic steering on a shortened axle
A ram mount sits in a load path that carries steering force, so the mounting position matters. Holding the ram close to the axle centerline keeps its angle and travel more consistent. Shortened Dana 60 axles and 9 inch housings have less room around the tube, which makes the cut-to-fit step and the gusset layout more important to get right.
Before cutting, mark the third member clearance and measure the speed holes and tube surfaces. Keep cuts away from welds and stress points where possible, and reinforce the area around any cutout as needed. Test the ram through full stroke with the axle supported and the wheels off the ground, and check the skidplate for contact with the tie rod or steering arms.
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | RM6007 |
| UPC | 816791023049 |
| Type | Ram mount (DIY) |
| Skidplate thickness | 1/4″ thick |
| Axle tube diameter | 3.125″ as designed (modifiable) |
| Gussets | 3 large gussets and 2 small side gussets |
| Differential skid | Bolt-on, hardware included |
| Compatible rams | PSC motorsports and Howe Performance double-ended hydraulic rams |
| Axle compatibility | Shortened Dana 60 axles and 9 inch housings |
| Sold as | Single |
Vehicle fitment
No vehicle is named for this ram mount. Its fit is set by axle: Dana 60 axles and 9 inch housings, including shortened versions. Check the mount against your axle for fit.
Artec sizes the mount to the axle tube and cutout rather than to a vehicle. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This is a DIY kit: you cut out the section of the mount that clears the third member and fabricate the fit to your axle. Reinforce around the cutout if it sits close to or overlaps the speed holes. Because Artec is not responsible for fit once the kit has been modified, check the mount dimensions against your axle before you start.
Work near steering components with the axle safely supported.
What’s included
Main ram mount, 3 large gussets, 2 small side gussets, bolt-on differential skid and hardware for the differential skid.
Not included: the double-ended hydraulic ram, which the mount is designed to hold. PSC motorsports and Howe Performance rams are the ones named by Artec.














