Overview
The Artec JK3010 is a raised-height front axle armor kit for the Dana 30 axle on the Jeep Wrangler JK, 2007-2018. It is a truss and armor system that Artec says is built to take serious abuse and reinforce the front Dana 30 JK axle, with a 1/4-inch thick truss top and 10Ga. gussets that strengthen both axle tubes, not only the long tube.
Choose this raised version for a drag link flip, which requires a minimum 3-inch lift and bumpstop extensions. The kit includes a raised tracbar bracket to suit that build. The components are precision cut and formed, which makes installation more straightforward.
Key features
- 1/4-inch thick truss top for the front axle
- 10Ga. gusseting that strengthens both axle tubes
- Front lower control arm skids
- Inner C gussets
- Heavy duty raised tracbar bracket
- Precision cut and formed components
Fabrication and clearance checks
A raised tracbar bracket changes the geometry the axle works through, so the setup needs a careful check after install. Drag link flips move the steering linkage and can affect how the steering centers, so test steering travel and tie rod clearance through full lock before driving. The bumpstop extensions are part of the same build and need to be checked against compression travel.
Because this kit is welded to the axle, plan for proper fixturing, heat control and a final inspection of every weld. Grind any sharp edges that could snag on rocks, and keep the axle tubes straight during the fit. After the first few trail outings, check the truss welds and skid mounts for cracks or loose hardware.
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | JK3010 |
| UPC | 816791021670 |
| Type | Axle armor kit |
| Fitment type | Vehicle-specific (inferred, see fitment section) |
| Sold as | Single |
| Tube diameter | Any |
| Truss top thickness | 1/4 inch |
| Gussets | 10Ga. |
| Tracbar bracket height | Raised |
| Factory-height companion kit | A/IJK3011 |
Vehicle fitment
The kit fits the front Dana 30 JK axle on the 2007-2018 Jeep Wrangler JK, and it is not narrowed by trim. Other models, including the Wrangler JL, Gladiator JT and earlier TJ and LJ, fall outside this kit’s fit.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Use the raised kit only for a drag link flip or a build where the tracbar bracket must sit higher. A lift that mounts the tracbar to the factory axle bracket uses the factory-height kit, A/IJK3011. The kit requires welding and general fabrication, and some grinding and fitment may be needed because every axle varies slightly.
What’s included
Front axle truss, front lower control arm skids, inner C gussets and a heavy duty raised tracbar bracket.
Not included: the lift kit, bumpstop extensions required for a drag link flip, and welding materials are not included.












