Overview
The Artec Industries JK4406 is a raised front tracbar bracket for Jeep Wrangler JK models with Dana 30 or Dana 44 front axles, for 2007-2018 Wrangler JK 2-door and 4-door vehicles. It replaces the factory tracbar bracket and offers raised tracbar holes at 1.75 inch and 3.0 inch, so it is built for a drag link flip setup rather than a stock-height tracbar.
The bracket lifts the factory sway bar mount 1.75 inch and moves the roll center 3 inches higher. A lift of at least 4 inches is required, and a 3.0 inch minimum lift with bumpstop extensions is the drag link flip minimum. Confirm your lift height and bumpstop setup before choosing this bracket.
Key features
- Raised tracbar holes at 1.75 inch and 3.0 inch
- Designed for a drag link flip kit
- Lifts the factory sway bar mount 1.75 inch
- Adjusts the roll center 3 inches higher for stability
- Made from 1/4 inch thick precision cut and formed mild steel
- Fits 2-door and 4-door Wrangler JK models
Drag link flip basics
A drag link flip moves the drag link to the opposite side of the axle so it can clear a raised front end. Because the steering geometry changes, the tracbar and sway bar also change angle, and the bumpstops take more of the axle’s travel. A raised tracbar bracket keeps the axle centered under those changed angles, which is why the bracket and the flip are usually planned together.
Before welding, check bumpstop contact, drag link clearance and steering movement at full lock. Inspect the tracbar bushings and bumpstops after the first few drives, since changed angles load them more. Replacing worn bushings at the same time avoids chasing play later.
- Bumpstop extensions
- Drag link and tracbar bushings
- Sway bar links
Specifications
| Brand | Artec Industries |
|---|---|
| Product code | JK4406 |
| UPC | 816791021731 |
| Material | 1/4 inch mild steel |
| Finish | Bare steel |
| Tracbar holes | Raised at 1.75 inch and 3.0 inch |
| Sway bar mount lift | 1.75 inch |
| Roll center | 3 inches higher |
| Application | Drag link flip kit |
| Quantity | Single bracket |
Vehicle fitment
This bracket is for the front Dana 30 or Dana 44 axle on Jeep Wrangler JK models, 2007-2018, in 2-door and 4-door form. It is built for a drag link flip, not a stock tracbar setup. The factory-height JK4407 is the choice for a lift that replaces the tracbar.
It is not for Wrangler TJ, LJ or JL vehicles. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This bracket requires welding and general fabrication. Some grinding may be needed because each axle sits slightly differently, and the drag link flip also needs bumpstop extensions. Dry-fit the bracket and check tracbar and sway bar clearance before welding.
What’s included
One JK4406 raised front tracbar bracket, bare steel.
Not included: The drag link flip kit, bumpstop extensions and welding or fabrication work are needed separately and are not included.














