Overview
The Artec BR1044 is a pair of upper link mounts designed to attach to a flat surface such as a truss. Artec cuts and bends each mount from 1/4 inch thick mild steel, and the bend adds strength so no extra reinforcement is needed. The mounts have a 2.63 inch inner width and are classed as control arm mounts. Installation requires welding and general fabrication.
Key features
- CNC cut and bent from 1/4 inch thick mild steel
- Bend adds strength without extra reinforcement
- 2.63 inch joint mounting width
- Designed for a flat surface such as a truss
- Sold as a pair
Planning a truss mount install
A truss upper link mount carries the pull of the link into the frame or truss, so the location decides how the link angles through its travel. Choose the mount position with the joint in place and the link set at its intended angle. A mount placed too close to a bend or weld seam can crack, so keep it on a clean, flat section wherever possible.
Because the mounts are welded, plan the order of work before striking an arc. Tack each mount, check that the joint moves freely through its full range, and then complete the welds. Keep the bend in each mount as cut, since the bend is part of the design and adds strength without extra reinforcement. Check the welds after the first few trail runs for any signs of cracking.
- Set the link angle before tacking the mount
- Check the joint moves freely through its travel
- Keep the bend in each mount as cut
- Inspect the welds after early trail use
Specifications
| Brand | Artec Industries |
|---|---|
| UPC | 816791020512 |
| Material | 1/4 inch thick mild steel |
| Joint mounting width | 2.63 inch |
| Finish | Bare steel |
| Quantity | Pair |
Vehicle fitment
Artec describes these mounts as universal application, and no year, make or model is named. Measure your truss and joint width to confirm they suit your build.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
These mounts are welded to a flat surface, so the install is not bolt-on. The bend is part of the design and should be kept as cut.
What’s included
The mounts are sold as a pair.
Not included: Welding equipment and the truss or link components the mounts attach to.












