Overview
The Artec JK4410 is a front axle armor kit for the Dana 44 front axle on the 2007-2018 Jeep Wrangler JK. It combines a truss system with lower control arm skids, inner C gussets and a raised height tracbar bracket, and it is designed to reinforce both axle tubes rather than only the long tube.
The top truss is 1/4 inch thick and the gusseting is 10Ga. The components are precision cut and formed, but the kit still calls for welding, general fabrication and some grinding, since every axle varies slightly. Buyers who need the stock height bracket should use the separate JK4411 kit, which is the factory height option.
Key features
- Truss top of 1/4″ thick material with 10Ga. gusseting
- Design strengthens both axle tubes, not just the long tube
- Precision cut and formed components for a straightforward fit
- Front lower control arm skids included
- Inner C gussets add support where the truss meets the axle
- Heavy duty raised height tracbar bracket for drag link flip setups that need a minimum 3″ lift with bumpstop extensions
Dana 44 axle wear and reinforcement
A Dana 44 front axle takes heavy loads during steering, braking and rock crawling, and the axle tubes can bend or crack when impacts land on the housing. Reinforcement works best when the existing axle is sound, so inspect the housing, ring gear area and seals for bends, leaks and cracks before fitting any armor. Plan the bracket and truss around the axle as it is, not as it should be.
Armor kits like this are welded, so a qualified fabricator should check clearances against brake lines, the differential and steering components before final welding. Keep the axle level and supported, and set the raised bracket at the height your drag link setup requires. After trail use, check the welds, gusset edges and bracket bolts for cracks or loosening.
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | JK4410 |
| UPC | 816791021755 |
| Type | Axle armor kit |
| Truss top thickness | 1/4″ thick |
| Gusseting | 10Ga. |
| Tracbar bracket | Heavy duty raised height |
| Tube diameter | Any |
| Sold as | Single |
Vehicle fitment
The kit fits the front Dana 44 JK axle on the 2007-2018 Jeep Wrangler JK.
It does not fit other Wrangler generations such as the YJ, TJ, LJ or JL, and it does not cover the rear axle. Check your year, model and trim before ordering.
Installation notes
This kit requires welding and general fabrication. Some grinding and fitment may be required, and every axle varies slightly, so some fabrication may be needed. If your lift replaces the tracbar and mounts to the factory axle bracket, Artec points to the factory height bracket #A/IJK4411 instead. For a drag link flip, which requires a minimum 3″ lift and bumpstop extensions, use the raised height bracket included in this kit.
Have a qualified fabricator do the welding and check clearances before the vehicle returns to the trail.
What’s included
Front axle truss, front lower control arm skids, inner C gussets and heavy duty raised height tracbar bracket.
Not included: the stock height tracbar bracket (#A/IJK4411), which Artec pairs with lifts that mount to the factory axle bracket. Welding equipment and fabrication tools are also needed.












