Overview
The Artec Industries BR1028 adjustable frame panhard mount, part BR1028, is a single frame-side mount for a Panhard bar (also called a track bar) in 3-link or 4-link suspension setups. It has three holes set 2, 3.25 and 4.5 inches down from the frame, so you can tune the bar’s position.
The mount is made for joints with a 2.625″ mounting width, including bushings and cartridge joints. It is universal fit with any tube diameter, so it is not designed around a particular vehicle.
Key features
- Three holes at 2, 3.25 and 4.5 inches drop from the frame
- Adjustable height for fine tuning the suspension
- Designed for 2.625″ mounting width joints
- Suits 3-link or 4-link scenarios
Setting bar height
A panhard bar keeps the axle centered side to side as the suspension moves up and down. The frame mount sets the bar’s height, and that height changes how much the axle shifts laterally through its travel. Small moves can make a noticeable difference on the road, so builders often test several frame holes before settling on one. Measure ride height and check the bar angle at each setting.
Frame-side mounts carry the bar’s loads into the frame, so the metal around the chosen hole should be clean and free of cracks before bolting on. Re-check hardware after the first few trail runs, since heavy articulation can loosen fasteners. Replace worn joints promptly, because play in the bushing lets the axle wander under load.
- Test a few frame holes before fixing the final height
- Keep the bar as level as the link layout allows
- Inspect the frame bracket for cracks after hard use
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | BR1028 |
| UPC | 816791020338 |
| Type | Panhard mount |
| Hole drop from frame | 2, 3.25 and 4.5 inches |
| Mounting width | 2.625″ |
| Tube diameter | Any |
| Quantity | Single |
| Fitment | Universal fit |
Vehicle fitment
This is a universal part and is not tied to a specific vehicle. Choose the mount for your link layout and the joint width you run.
The mount is built around a 2.625″ mounting width, so it will not suit joints of other widths. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Choose the frame hole height that suits your suspension geometry. Check axle centering after installation, because a panhard bar changes lateral position.
What’s included
A single adjustable frame panhard mount.
Not included: the bushing or cartridge joint that fits the 2.625″ mounting width.









