Overview
The Artec BR1009 is a lower link frame bracket, a control arm mount from Artec Industries with part number BR1009. It holds a common sized Cartridge Joint such as a Johnny, Flex or Ballistic joint, using a 2.625 inch mounting width and a 9/16 inch bolt hole. Builders who run cartridge joints on the lower link get a bracket that protects the joint and its grease fitting while looking like a custom fabrication piece.
Artec built this bracket to fix problems it sees in generic frame brackets: poor grease fitting access, unprotected joints and plain angle iron or C-channel shapes. The formed body is meant to look like it was designed for the frame from the start. Its tapered sides let it mount at an angle on the frame without much bracket hanging off the side, so less of it slides over rocks.
Key features
- Grease fitting access on top, so the joint can be mounted grease fitting up.
- Bottom skid plate wraps around the joint to take direct impacts and reduce premature wear.
- Skid plate design does not restrict joint movement.
- Tapered sides allow angled mounting on the frame with less bracket sliding on rocks.
- 2.625 inch mounting width with 9/16 inch bolt hole for common sized Cartridge Joints.
- Can be drilled out to a larger hole for 1.25 inch rod ends used with spacers.
- Made from 1/4 inch thick boxed steel plate for strength and impact resistance.
Mounting angle and clearance
A lower link frame bracket locates the joint where the control arm pivots, so its angle and height affect how the link moves through travel. Mounting the bracket at an angle keeps more of the frame behind it and reduces the bracket hanging off the side where rocks can catch it.
Before welding or bolting, hold the bracket against the frame and cycle the axle through its full travel. Watch for contact with tires, brake lines, fuel lines and the frame rail. Trim or reposition the bracket as needed, since a small change in angle can clear a tight spot.
Grease access matters for long joint life. Keep the grease fitting reachable after mounting, and avoid positions where mud or debris packs around it. Recheck the bracket and bolts after the first trail runs.
- Hold the bracket in place before final mounting
- Cycle the axle through full travel to check clearance
- Keep the grease fitting accessible
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | BR1009 |
| UPC | 816791020161 |
| Type | Control arm mount |
| Mounting width | 2.625 inch |
| Bolt hole | 9/16 inch |
| Material | 1/4 inch thick boxed steel plate |
| Tube diameter | Any |
| Sold as | Single |
Vehicle fitment
This bracket is universal fit with any tube diameter and is not built for one make or model. Check frame clearance for the 2.625 inch mounting width and match the joint size before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Mount the joint grease fitting up so the fitting stays on top, away from impacts from below. Drill the bolt hole out only if your joint uses 1.25 inch rod ends, and use spacers as the design calls for.
What’s included
One bracket, sold as a single.
Not included: cartridge joint and any hardware or spacers needed for your joint.














