Overview
The Artec JK4426 is a rear track bar bracket that replaces the factory JK bracket on lifted vehicles with a 2.0 inch lift or higher. It is cut and formed from 1/4 inch mild steel and has several raised track bar holes. A track bar, also called a Panhard bar, locates the axle side to side, so the bracket’s position affects the roll center. Welding is required to install it.
Key features
- Replaces the factory bracket on lifted JK models
- Several raised track bar holes
- Raises the roll center for added stability
- Made from 1/4 inch mild steel
- Bare steel finish
Setting the track bar
A track bar only works as intended when the axle sits centered under the vehicle. If one end of the bar is set shorter or longer than the other, the axle will shift toward one side at ride height, and the steering can feel off center. Setting the bar length and bracket position with the vehicle at its normal ride height gives the most consistent result.
Raising the track bar mount changes the angle of the bar, which in turn changes how the axle moves through its travel. Check the bar ends and bushings at the same time as the bracket, because a worn joint at either end lets the axle drift even with a solid bracket. Re-check the centering after tire or lift changes, since those shift the axle position.
- Center the axle with the vehicle at ride height
- Check both ends of the track bar for play
- Re-check centering after tire or lift changes
- Replace worn bar ends when play is clear
Specifications
| Brand | Artec Industries |
|---|---|
| UPC | 816791021823 |
| Material | Mild steel, 1/4 inch thick |
| Finish | Bare steel |
| Lift height for use | 2.0 inch or higher |
| Type | Panhard mount, single |
Vehicle fitment
It is a universal fit Panhard mount for the JK rear track bar location. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This bracket is not bolt-on. Welding is required, and some trial and error may be needed to find the ideal ride with the raised holes.
What’s included
One track bar bracket is included.
Not included: The track bar itself and welding equipment.









