Overview
The Artec TB1011 is a set of two flat shock tabs cut from 1/4 inch thick steel. Each tab has a 1/2 inch bolt hole with the hole center 1.25 inch from the flat. It is a universal application mounting tab for shocks.
Key features
- Cut from 1/4 inch thick steel
- 1/2 inch bolt hole
- Hole center 1.25 inch from the flat
- Two tabs included
Welding and mounting tips
Shock tabs carry the load of a damper that controls body and axle movement, so the weld and the metal around the bolt hole matter as much as the tab itself. Before welding, clean the mounting surface down to bare metal and dry-fit the shock to confirm it sits square without binding at full extension and compression. Welds on a flat tab should run along the full contact edge rather than a few spots, and fabrication work is best done by someone comfortable with structural welds on a frame or axle.
Once installed, look at the tab and weld after the first few trail runs and periodically afterward. Hairline cracks near the hole, rust creeping along the weld, or a shock that has started to rattle on its bolt all suggest the mount needs attention. Worn tabs and shocks are often replaced together with fresh bushings, which keeps the geometry consistent.
Specifications
| Brand | Artec Industries |
|---|---|
| UPC | 816791023605 |
| Material | Steel, 1/4 inch thick |
| Bolt hole | 1/2 inch |
| Hole center | 1.25 inch from flat |
| Quantity | Two tabs |
Vehicle fitment
These are universal mounting tabs and no vehicle year, make or model is named. Check the tab size and bolt hole against the shock you plan to mount.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Two flat shock tabs are included.
Not included: Shocks, bolts and the welding or fabrication needed to attach the tabs.









