Overview
The TM107 is a front lift kit that raises the front 2.5 inches with torsion keys. The rear stays at its factory height. It is a complete leveling kit, so no separate parts are needed to raise the vehicle, and it is covered by a lifetime warranty.
The front lift works through torsion keys, and the spacer is steel in a gray finish. A shock relocation bracket and the hardware needed for installation come with the kit. The kit has no bump stops, and no track bar drop is included. It suits owners who want a 2.5-inch front increase with no change at the rear.
Key features
- 2.5-inch front lift with torsion keys
- Front lift only
- Shock relocation bracket included
- Hardware kit included
- Gray steel spacers
- Lifetime warranty
Choosing a front lift height
Front height is the first decision with any leveling kit. Adding 2.5 inches up front changes the angle the front driveshaft and steering components work at, so think about how much rake the rear will show after the change. Torsion keys give a way to fine-tune the result after installation.
Torsion key kits place extra load on front suspension joints, so inspect the control arm bushings and ball joints before the work begins. Shock length also matters, since the relocation bracket changes where the shock mounts. Check that the shock travel still suits the new height and that the brake lines have enough slack.
- Inspect control arm bushings before installation
- Check shock travel after the front rises
- Confirm brake line slack at full droop
- Re-torque hardware after the first drive
Specifications
| Brand | Trail Master |
|---|---|
| Part number | TM107 |
| UPC | 614901093087 |
| Front lift height | 2.5 inches |
| Front lift method | Torsion keys |
| Rear lift method | Front lift only |
| Shock relocation bracket | Included |
| Bump stops | None |
| Track bar drop | Not included |
| Spacer material | Steel |
| Finish | Gray |
Vehicle fitment
Before ordering, match the TM107 to your truck’s year, model and trim.
Installation notes
Torsion keys are the adjustment point for front height, so the 2.5-inch figure depends on how they are set. Because the lift changes front geometry, the alignment should be rechecked after the kit is installed.
The rear stays at its factory height, because the kit has no bump stops and no track bar drop to change the rear geometry.
What’s included
Torsion keys, a hardware kit and a shock relocation bracket, with gray steel spacers.
Not included: a track bar drop.









