Overview
The Trail Gear TG high pinion housing, part number 140071-1-KIT, is a new housing for front or rear use. It is the housing type for Toyota eight-inch differentials, and the high pinion design is intended for heavy use in that application.
A high pinion housing raises the pinion gear above the centerline of a standard differential. This is commonly used to correct driveline angle problems, since the pinion sits several inches higher than on a standard four-cylinder or V6 housing. In a front axle, the ring gear runs on the stronger side of the gear set, and the reverse-cut ring gear adds to that strength.
Key features
- Brand-new housing with no core required
- High pinion layout for driveline angle correction
- Reverse-cut ring gear arrangement
- Usable as a front or rear housing
- Includes caps, cap bolts, adjuster wheels, lock tabs and lock tab bolts
- Oil slinger included
Setting up the pinion
Driveline angle is the reason most people choose a high pinion housing, so the setup should be measured before and after the swap. Check the pinion angle against the transmission or transfer case output and the drive shaft angles at both ends. A small mismatch can cause vibration, early U-joint wear and rough driving on the highway, so correct it before the truck sees heavy use.
Gear setup in a housing like this is sensitive to backlash and pinion depth, so set both carefully and check the contact pattern with marking compound before final assembly. Use fresh gear oil, install the oil slinger correctly, and check the seal areas for leaks after the first few drives. Replacing the pinion bearings during the swap is common practice when the housing is opened. A careful break-in with gentle loads helps the new gears seat evenly.
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 140071-1-KIT |
| UPC | 70000621390 |
| Position | Front or rear |
| Housing type | Toyota, high pinion |
| Core | Not required |
| Hardware | Caps, cap bolts, adjuster wheels, lock tabs and lock tab bolts, oil slinger |
Vehicle fitment
The housing is for Toyota eight-inch differential applications in the high pinion layout. Confirm the make, model, year and axle position for your vehicle before ordering.
Confirm the make, model, year and axle position with Trail Gear before ordering, since the product is listed without a vehicle.
Installation notes
The housing arrives with its caps, adjuster wheels and lock tabs, so that hardware does not need to be sourced separately. Driveline angle should be checked after installation, since that is the reason for the high pinion design.
What’s included
A new high pinion housing with caps, cap bolts, adjuster wheels, lock tabs, lock tab bolts and an oil slinger, part 140071-1-KIT.












