Overview
The Trail Gear Rock Assault Seal Housing Kit, part number 144043-KIT, is a 9 inch axle seal housing machined from billet aluminum. It has three O-rings on the outer surface and a double seal on the inside, which keeps differential fluid in the axle.
The housing is tapered on the inside so the axle shaft lines up with it during installation, which helps protect the seals and the housing.
The double seal stops fluid from leaking through or around the seals during rock crawling on an angle or fast highway driving. Keeping fluid in the differential also keeps it away from the brakes and tires, where a leak could become dangerous. The three outer O-rings block fluid flow between the axle tube and the seal housing, and the set screw keeps the housing from moving or being pushed out when the axle shafts go in.
Key features
- Machined from billet aluminum
- Three O-rings on the outer surface seal the housing to the axle tube
- Double seal on the inside
- Tapered inside to guide the axle shaft during installation
- Secured in place with a set screw
Choosing a 9 inch seal setup
A seal housing is only as good as the axle around it. Confirm the axle is a 9 inch unit before buying, since the bore and outer O-ring surface must match the axle tube. Measure the tube diameter where the O-rings sit, and check for pitting or scoring that could let fluid pass the rings.
Plan for fresh gear oil at the correct level once the housing is in place. Inspect the axle shaft surfaces that ride through the seals for grooves or burrs, and smooth any found before installation. Seals work best when the housing, shaft and fluid are all in good condition.
- Confirm the axle is a 9 inch unit
- Check the axle tube for pitting or scoring
- Inspect axle shaft surfaces for grooves
- Use fresh gear oil at the correct level
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 144043-KIT |
| UPC | 70000621345 |
| Part type | Axle seal housing kit |
| Axle size | 9 inch |
| Material | Billet aluminum |
| Outer O-rings | Three |
| Inner seals | Two |
| Retention | Set screw |
Vehicle fitment
It is a universal fit for 9 inch axles.
The kit is sized for a 9 inch axle and is not a vehicle-specific part. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The set screw holds the seal housing in place so it cannot move or be pushed out when the axle shafts are installed, and the taper guides the shaft into the double seal.









