Overview
The TeraFlex high steer knuckle kit 4390870 (TER4390870) is a pair of cast ductile iron high-steer knuckles for the 2007-2018 Jeep Wrangler JK. The kit includes one driver-side and one passenger-side knuckle.
The knuckles are reinforced in the areas where the stock JK steering setup takes the most stress and deflection. They are designed for JKs with 4-6 inches of lift, keep steering geometry for highway driving, and raise tie rod ground clearance by over 1-1/8 inch.
The kit changes the steering linkage position at the knuckle, so TeraFlex ties it to a flipped drag link and a specific wheel range.
The high-steer design also moves the tie rod up, which raises its ground clearance and reduces tie rod damage and bending.
The kit includes one knuckle for each side.
Key features
- Cast heavy-duty ductile iron
- Reinforced in high-stress areas
- Designed for 4-6 inches of lift
- Raises tie rod ground clearance by over 1-1/8 inch
- Driver and passenger knuckles included
- Fits all JK Wrangler models
Choosing steering parts for lift
Steering parts carry more load once a Jeep is lifted, because larger tires and changed joint angles push the tie rods and knuckles harder. A high steer setup moves the tie rod up and away from rocks and trail debris, which helps protect the linkage on rough ground. Before adding any steering upgrade, look at the whole front end, including the track bar, drag link and wheel offset, since all of them affect steering geometry together.
Inspect the knuckle and tie rod area often on a lifted vehicle. Look for play at the joints, cracks near welds or castings, and any bending of the steering arms after hard trail runs. Torque fasteners to specification and recheck them after the first few drives on a new setup, since loosened hardware is one of the first signs of trouble.
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | TER4390870 |
| Material | Heavy-duty ductile iron, cast |
| Lift range | 4-6 inches |
| Tie rod clearance gain | Over 1-1/8 inch |
| Minimum wheel diameter | 17 inches |
| Maximum backspacing | 5 inches |
| Fit type | Direct fit |
Vehicle fitment
The kit fits the 2007-2018 Jeep Wrangler JK, including Rubicon and Unlimited models.
The TJ, LJ and JL are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit must be used with a flipped drag link, and may require additional modification to maintain steering geometry. Wheels must be at least 17 inches in diameter with no more than 5 inches of backspacing.
What’s included
One driver-side and one passenger-side high steer knuckle.
Not included: a flipped drag link.









