Overview
The Trail Gear TG Super Metal Knuckle Studs Hardware Kit, part number 186115-1-KIT, is a set of replacement knuckle studs for Toyota front solid axle knuckles from 1979-1985. The studs are stronger and longer than stock Toyota studs.
The studs are 1/4 inch longer than stock to suit aftermarket steering arms, and Trail Gear positions them as a first choice for knuckle hardware when repairing or upgrading a high-steer system.
These studs are made from a proprietary metal used only by Trail Gear, and they are built to Trail Gear’s own specifications. They are designed as a lower-cost option than Trail Gear Magnum Studs while offering significant strength over OEM standard studs.
Key features
- Stronger and longer than stock Toyota knuckle studs
- Made from a proprietary metal; Trail Gear says testing exceeded Class 12.9 standards
- Longer than stock to accommodate aftermarket steering arms
- Integrated 8mm hex head for easy removal
- Positioned as a lower-cost alternative to Trail Gear Magnum Studs
Torque and thread prep
Stud work on a solid axle knuckle carries real load, so the threads and seats need to be clean and undamaged before any new stud goes in. Remove old thread residue with a wire brush and check the knuckle bores for galling. Apply thread locker only where the instructions call for it, since too much can make torque readings misleading. Taking time over preparation helps the studs seat evenly and reduces the chance of loosening under steering loads.
After the first drive, recheck the stud nuts and look for signs of movement, such as witness marks or a clicking sound when turning. High-steer conditions push the steering arm and knuckle studs harder than stock, so inspect the steering arm, tie rod ends and drag link at the same time. Replace any worn or damaged parts rather than reusing them, and keep the torque sequence the same each time you service the axle.
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 186115-1-KIT |
| UPC | 70000633169 |
| Part type | Knuckle stud hardware kit |
| Length versus stock | 1/4 inch longer |
| Head | Integrated 8mm hex |
| Stud torque | 40 ft-lbs in the knuckles |
| Stud nut torque | 75 – 80 ft-lbs |
| Thread locker | Locktight recommended on lower threads |
Vehicle fitment
It fits 1979-1985 Toyota front solid axle knuckles.
The kit is for Toyota front solid axle knuckles only. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Trail Gear recommends using Locktight on the lower threads when installing knuckle studs. The studs should be tightened to 40 ft-lbs in the knuckles, and the stud nuts to 75 – 80 ft-lbs.









