Overview
A 9/16 inch bore high misalignment spacer, the Trail Gear 186030-KIT gives a rod end room to articulate without contacting its mounting surface. It is a joint accessory rather than a vehicle-specific part.
The ball’s edge turns into the rod end body through the spacer’s diameter, which supports articulation and suspension travel. Longer rod end life is another intended benefit of that geometry.
Key features
- 9/16 inch bore
- Allows the ball’s edge to turn into the rod end body
- Cited for greater articulation and more suspension travel
- Cited for longer rod end life
- Part number 186030-KIT, UPC 70000621682
Setting up the joint
A joint that moves more needs clearance in every direction it travels, not just at the stud. When the suspension cycles, watch for the rod end contacting the bracket, the boot or a nearby brake line. A spacer can shift where the joint sits, so the path of motion changes and should be checked again after every adjustment.
A practical check is to cycle the suspension slowly by hand with the vehicle safely supported, then look for rubbing or binding at full extension and full compression. Re-torque fasteners after the first drive, and keep the spacer faces clean so they seat evenly. Replace a joint that shows play or grit contamination instead of relying on a spacer to hide it.
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 186030-KIT |
| UPC | 70000621682 |
| Bore | 9/16 inches |
| Type | High misalignment spacer |
| Fitment | Universal fit |
Vehicle fitment
Fitment depends on the joint rather than the vehicle, so the 9/16 inch bore and joint size decide whether it suits your setup.
Compare the 9/16 inch bore with the joint you intend to use. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Set the spacer on the joint, then verify it does not restrict the rod end’s rotation when the suspension cycles through its travel.
What’s included
Check the package contents against your installation before starting.






