Overview
The Trail Gear 140298-KIT is a Dana 60 ring and pinion setup kit made with Timken bearings and races. It works with standard and reverse cut gear sets, all ratio carriers, and front or rear Dana 60 axle housings.
It is universal fit and is tied to the Dana 60 axle, not to a make, model or years.
Key features
- Built with quality Timken bearings and races
- Works with standard and reverse cut gear sets
- Works with all ratio carriers
- Works with front or rear Dana 60 axle housings
Setting up a ring and pinion
A ring and pinion set needs careful setup to run quietly and last. The gear contact pattern, backlash and bearing preload all affect noise and wear, so the work usually needs gauges and a patient technician. Reverse cut gear sets are matched to a specific pinion and carrier, so check the set before assembly.
Timken bearings and races help the carrier and pinion hold alignment, but they must be seated properly and preloaded as the service procedure directs. Install new pinion seals and clean all parts before assembly. After setup, break in the gear set gently and check for leaks and noise on the first few drives.
- Check the gear contact pattern
- Set backlash and bearing preload
- Install new pinion seals
- Check for noise and leaks after break-in
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 140298-KIT |
| UPC | 70000621810 |
| Axle type | Dana 60 |
| Bearings | Timken bearings and races |
| Gear set compatibility | Standard and reverse cut |
| Housing | Front or rear |
Vehicle fitment
No vehicle is named. The kit is tied to the Dana 60 axle, which is an axle type rather than a vehicle, so match your current housing and gear set to the kit before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Gear sets need professional setup and break-in, so a qualified installer should handle the work with the correct tools.
What’s included
The kit includes Timken bearings and races. Compare every component with your gear set before starting.









