Overview
The Fabtech FTS43 is a .75 inch misalignment spacer from Fabtech, filed under misalignment spacers and washers. Fabtech describes right hand threaded Teflon heim ends available as single units for specialty fabrication work. No vehicle is named, so the spacer should be checked against your own build before use.
Setting up a misalignment spacer
A misalignment spacer lets a heim joint sit in line with the part it connects when the mounting points do not match. The spacer takes up the offset so the rod can pivot freely and the threads can engage fully. Setting the length correctly matters, because a spacer that is too short or too long can bind the joint.
Bore fit is important. A spacer bore that is too tight can stress the pin, and one that is too loose can allow movement and wear. Check the pin diameter against the bore before assembly, and inspect the joint for wear each time the linkage is serviced, paying attention to play and cracking.
- Measure the offset before selecting the spacer
- Confirm the thread direction matches the joint
- Use a jam nut to lock the spacer once it is set
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FTS43 |
| UPC | 674866011526 |
| Size | .75 inch |
| Bore | 9/16 inches |
| Thread direction | Right hand |
Vehicle fitment
No vehicle is named for this spacer, and no year, make, model or axle is given.
Installation notes
Because the bore is 9/16 inches, check that it matches the pin or bolt it will carry before assembly.
What’s included
Check the package contents against your installation before you assemble.






