Overview
The Trail Gear Longfield Axle, part number 301712-1-KIT, is a 24-spline Birfield front left replacement axle shaft for the 1990–2008 Toyota Land Cruiser.
The axle is a Longfield design with 24 splines and a Birfield joint, sized for the front left position. It is a direct-fit replacement axle shaft. Compare the spline count and joint type with the shaft being replaced before installation.
Key features
- Longfield axle, replacement axle shaft
- 24 spline
- Birfield joint
- Front left position
- Direct fit
- It is made for the 1990–2008 Toyota Land Cruiser Base.
Axle shaft wear signs
The axle shaft carries engine torque from the differential to the wheel, so wear or damage shows up as vibration, clicking on turns or a grease leak at the joint. Birfield joints use internal balls that need to stay clean and lubricated. Checking the boot and joint during an axle job helps prevent sudden failure.
When replacing a front axle shaft, look at the hub, bearings and seals as well. A new shaft on a worn hub can vibrate or wear quickly. Clean mating surfaces, use fresh gaskets, and make sure the axle seats fully before the wheel is refitted.
- Inspect the CV boot for tears
- Check hub bearings for play
- Look for grease leaks at the seal
- Recheck fasteners after hard off-road use
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 301712-1-KIT (also shown as TGI301712-1-KIT) |
| UPC | 700006930071 |
| Product type | Replacement axle shaft |
| Style | Longfield axle |
| Spline count | 24 spline |
| Joint | Birfield |
| Position | Front left |
| Fitment type | Direct fit |
Vehicle fitment
The manufacturer fitment list for the Trail Gear 301712-1-KIT covers the 1990–2008 Toyota Land Cruiser (Base).
The list covers the 1990–2008 Land Cruiser Base model only, and this axle is for the front left side. Other Toyota models and the right side are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Follow the installation steps carefully and torque fasteners to the correct values for your vehicle.
- Check the part against your vehicle before starting work.
- Re-check fasteners after the first miles of driving, and again after hard off-road use.
- Axle shafts are driveline and safety parts; professional installation is recommended.
- Replace related seals and check the hub and wheel bearings while the axle is out, and check for leaks, vibration or noise after the first drive and again after hard use.
What’s included
One front left axle.
Not included: Hubs, seals and hardware are not included, so check the package contents against your installation before starting.









