Overview
The Trail Gear 120166-1-KIT is a set of rear frame reinforcement plates for the 1995 to 2004 Toyota Tacoma. The plates are 3/16 inch thick and are meant for the rear section of a frame that Trail Gear describes as notorious for bending and cracking.
The C-channel frame design is linked to rear axle wrap and wheel hop, and Toyota reinforced the frame on the 05-09 Tacoma and FJ Cruiser. These plates are reinforcement for the earlier trucks.
Key features
- Rear frame reinforcement plates at 3/16 inch thickness
- Designed for the rear section of 1995 to 2004 Tacoma frames
- It is a direct fit for the 1995 to 2004 Tacoma.
- Trail Gear part number 120166-1-KIT
Frame reinforcement and axle wrap
Older body-on-frame trucks rely on the frame to hold the rear axle and leaf springs in position. When the rear section flexes under load, the wheel can lift and the axle can rotate under acceleration, which is the behavior often called axle wrap. Reinforcing the rear frame section limits that flex, but it does not change suspension geometry, so the springs and shackles still need regular inspection.
Before fitting any plate, raise the truck safely, inspect the frame for existing cracks around the spring hangers and crossmember, and address any damage first. Shock mounts, bushings and U-bolts should be checked at the same time because worn parts increase movement at the rear end. Keep an eye on the frame after the first few trail outings for new hairline cracks.
- Inspect spring hangers and crossmember welds
- Check U-bolts and shackle hardware for tightness
- Look for new cracks after rough trail use
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 120166-1-KIT |
| UPC | 70000621825 |
| Position | Rear |
| Type | Frame reinforcement plates |
| Plate thickness | 3/16 inch |
| Fitment | Direct fit, 1995 to 2004 Tacoma |
Vehicle fitment
Trail Gear lists these plates as direct fit for the 1995 to 2004 Toyota Tacoma, including Base, Limited, Pre Runner, S-Runner and SR5 trims.
The 05-09 Tacoma and FJ Cruiser were reinforced at the factory and are not covered by this kit. Match your vehicle’s year, model and trim before ordering.
What’s included
Rear frame reinforcement plates at 3/16 inch thickness make up the kit. Confirm the plate count and hardware against the package before starting.









