Overview
The Trail Gear 120165-1-KIT is a rear frame box kit for the 1995 to 2004 Toyota Tacoma. It boxes in and reinforces the inside of the frame, which Trail Gear says is notorious for bending and cracking on these trucks.
Trail Gear ties the Tacoma’s C-channel frame to rear axle wrap and wheel hop, and presents this kit as its answer. Two 3/16 inch thick plates enclose the channel, and two pieces of DOM tubing add reinforcement and a mounting point for the upper shock.
Key features
- Two 3/16 inch thick plates that box in the rear frame
- Two pieces of DOM tubing: one for reinforcement, one as an upper shock mount
- Upper shock mount tube comes with metal sleeves and the necessary hardware
- Direct fit for the 1995 to 2004 Toyota Tacoma
- Trail Gear part number 120165-1-KIT
Rear axle wrap and shock mounts
Rear axle wrap happens when the axle rotates under hard acceleration or braking, and it can make the rear end hop on loose surfaces. A boxed frame helps keep the rear section from twisting, but the axle, leaf springs and shocks still do most of the work. Mounts that hold the shocks should stay tight and free of cracks, since they carry the force of every bump.
When an upper shock mount tube is added, check how the shock eye sits on the tube and whether the sleeves bind. Re-check hardware after the first few drives and at regular service, and inspect welds around the mount for hairline cracks. Keep the rear bump stops and leaf spring bolts in good condition too, since worn parts can change how the axle moves.
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 120165-1-KIT |
| UPC | 70000621420 |
| Position | Rear |
| Type | Frame box kit |
| Plate thickness | 3/16 inch |
| Tubing | Two pieces of DOM tubing |
| Upper shock mount tube | Includes metal sleeves and hardware |
Vehicle fitment
It is a direct fit for the 1995 to 2004 Toyota Tacoma, covering Base, Limited, Pre Runner, S-Runner and SR5 trims.
Later Tacoma years and other vehicles are outside this fit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The upper shock mount tube comes with metal sleeves and the hardware needed to mount it. Confirm whether the plates are welded in place before starting the work.
What’s included
Two 3/16 inch thick plates, two pieces of DOM tubing, metal sleeves and the necessary hardware for the upper shock mount tube.









