Overview
The Moog inner tie rod end is a steering part sold individually. It connects the steering rack or center link to the tie rod, letting the steering change the wheel angle without binding. It fits the 2002 to 2005 Ford Excursion and 1999 to 2005 Ford Super Duty, in left-hand and right-hand inner positions.
MOOG says its Problem Solver line is designed for like new steering, easier installation and longer life. The company describes its powdered metal gusher bearing as letting grease flow to the stud, a patented cover plate that allows tighter tolerances, and a full ball metal stud that rotates through 360 degrees. Patent pending Sunoloy coated bearings are also described.
Key features
- Left-hand and right-hand inner positions
- Gusher bearing that routes grease to the stud
- Patented cover plate that allows tighter tolerances
- Full ball metal stud that rotates through 360 degrees
- Sold individually
Inner tie rod wear signs
The inner tie rod end takes the side load of the steering linkage, so wear often shows up as a loose feel, clunking on turns or uneven tire wear. Play can be checked by grasping the tie rod near the inner end with the front end lifted and moving it side to side. Any movement beyond a slight amount points to a worn end.
Because the inner end sets toe, a new one should be followed by an alignment. Look at the rack boot for tears, since grease loss or dirt speeds up wear in the joint. Replacing the boot and clamps during the job is usually cheaper than a second repair later.
- Check for play by hand with the front end lifted
- Inspect the rack boot for tears and grease
- Look for uneven inner tire wear
- Recheck toe after replacement
Specifications
| Brand | Moog |
|---|---|
| UPC | 80066297262 |
| Product type | Inner tie rod end |
| Position | Left-hand inner and right-hand side |
| Listed applications | 2002 to 2005 Ford Excursion; 1999 to 2005 Ford Super Duty |
| Sold as | Individually |
Vehicle fitment
The 2002 to 2005 Ford Excursion is a single model with years, so it matches directly. The Super Duty fit covers a range of trucks, so confirm the exact model, year and steering side on your vehicle before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
An inner tie rod end sets toe along with the outer end, so the front alignment should be checked after replacement. The boot and clamp on an inner end often need attention at the same time, so inspect them during the job.
What’s included
One inner tie rod end, sold individually.
Not included: Boots, clamps and jam nuts are sold separately.









