Overview
The Moog left-hand outer tie rod end is a steering part sold individually. The outer tie rod end connects the steering link to the knuckle on the left side and lets the wheel pivot as the steering turns. It is the left-hand outer position for 2005 to 2015 Ford Super Duty trucks.
MOOG says its Problem Solver line is built for like new steering, ease of installation and longer life. The company describes its powdered metal gusher bearing as routing grease to the stud, a patented cover plate that allows tighter tolerances, and a full ball metal stud that rotates through 360 degrees for consistent movement. Patent pending Sunoloy coated metal bearings are said to give smooth stud swing.
Key features
- Fits the left-hand outer position
- Gusher bearing that routes grease to the stud
- Patented cover plate
- Full ball metal stud with 360 degrees of rotation
- Sold individually
Toe settings and steering centering
Toe is the angle at which the front wheels point relative to each other, and the outer tie rod end is one of the parts that sets it. Small changes at this joint can scrub tires quickly, so wear on the outer end often appears first as feathered edges across the tread. A steering wheel that sits off center is another common sign that the joint or the setting needs attention.
When the end is replaced, mark the thread position on the tie rod so the new end starts near the old setting before alignment. Tighten the castle nut and use a fresh cotter pin where the design calls for one, then recheck for free play before driving the truck any distance.
- Uneven tire wear along one edge
- Wandering or loose steering
- Torn rubber boot on the joint
- Steering wheel off center on the road
Specifications
| Brand | Moog |
|---|---|
| UPC | 80066389271 |
| Product type | Outer tie rod end |
| Position | Left-hand outer |
| Listed application | 2005 to 2015 Ford Super Duty |
| Sold as | Individually |
Vehicle fitment
Ford Super Duty is covered for 2005 to 2015, but no model is named for this part. Confirm your exact model, year and steering side before ordering, since the range is wide.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
An outer tie rod end changes toe, so a front alignment is normally needed after replacement. Tighten the castle nut to specification and install a new cotter pin if the design uses one.
What’s included
One left-hand outer tie rod end, sold individually.
Not included: The nut, cotter pin and boot are not included. Check those parts against your installation before starting.









