Overview
The TeraFlex 4107122 is a right hand weldable threaded insert in the 7/8 Inches -14 size, for welding into control arm length tubing with a minimum 1-1/8 Inches inside diameter. It is a custom link component rather than a bolt-on part.
TeraFlex’s general note pairs the 7/8 inch inserts with 18 threads per inch, while this item is marked -14. Check the thread count against the mating end before welding.
Key features
- Right hand thread direction
- 7/8 Inches -14 thread size
- Weld-in design for control arm length tubing
- Requires tubing with a minimum 1-1/8 inch inside diameter
Choosing mating hardware
Matching hardware matters more with a fabricated link than with a bolt-on part, because the thread, the tube and the end all have to agree before welding. Confirm the thread pitch of the end you plan to use, and do not assume a mismatch will show up in a quick visual check. A thread that is a little off can still thread on partially and load unevenly under articulation.
Plan the link layout before you cut. Mark the tube length from the center of the mounting points, leave room for the insert to sit square, and keep the weld zone clear of bends. Right hand threads are common on steering and suspension ends, so confirm the direction on the other side of the link too.
- Verify thread pitch on the mating end before cutting tube
- Keep welds clear of bends and tube ends
- Dry fit the full link before final welding
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 4107122 |
| UPC | 843885025528 |
| Thread size | 7/8 Inches – 14 |
| Thread direction | Right hand |
| Minimum tube ID | 1-1/8 Inches |
| Jam nut | Not included |
| Fitment | Universal fit |
Vehicle fitment
No vehicle is named, and TeraFlex marks this insert universal fit. Fitment therefore depends on the link and the end you build with, not on a model.
Confirm the -14 thread against your end, since a thread count mismatch may prevent a proper fit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Weld only into tubing at or above the 1-1/8 inch minimum inside diameter.
What’s included
One weldable threaded insert, part number 4107122.
Not included: Jam nut and mating Monster end.









