Overview
The TeraFlex 4107121 is a weldable threaded insert for building custom links. Weld it to control arm length tubing to make a threaded end; this 7/8 Inches – 18 left hand version is the medium and small size made for TeraFlex Monster ends.
TeraFlex also makes a larger 1-1/4 inch 12 tpi insert, which needs at least 1.5 inch ID tubing. The 4107121 needs tubing with at least 1-1/8 Inches inside diameter, so the two sizes are not interchangeable.
Key features
- Weldable threaded end for control arm length tubing
- Left hand thread, 7/8 Inches – 18
- Requires a minimum tube ID of 1-1/8 Inches
- Sized for the medium and small TeraFlex Monster ends
- Jam nut not included
Before welding in
Threaded inserts like this one turn a length of tubing into an adjustable link end. Once welded, the insert accepts a rod end, so the link can be shortened or lengthened to set caster and axle angle. Because the threads carry load at the joint, the weld needs to be full and even all the way around the insert, with no gaps where the tube meets the insert.
Before cutting tubing, measure the bore carefully and confirm the wall thickness will support the weld without burning through. Clean the mating surfaces of paint, rust and oil, and dry-fit the insert so the thread sits square to the tube. After welding, check the thread with a jam nut and rod end, then inspect the weld for cracks once the link has been in use for a few trips.
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 4107121 |
| UPC | 843885025511 |
| Thread size | 7/8 Inches – 18 |
| Thread direction | Left hand |
| Minimum tube ID | 1-1/8 Inches |
| Jam nut included | No |
| Fitment | Universal Fit |
Vehicle fitment
This insert is a weldable fabrication part marked Universal Fit, so suitability depends on the thread, the tubing ID and the Monster end it is built for.
The 1-1/4 inch 12 tpi large insert is a different size and needs 1.5 inch ID tubing, so do not substitute it. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Weld the insert into control arm length tubing with at least 1-1/8 Inches inside diameter. Use a welder comfortable with steel tubing, and wear eye and fire protection while welding.
What’s included
The weldable threaded insert, part number 4107121.
Not included: A jam nut, and the control arm length tubing the insert is welded into.









