Overview
The TeraFlex 3990060 is a rear axle bracket bumpstop pad for the JK rear CRD60 axle bracket. It is laser cut from 1/4 inch steel and formed to position the bumpstop for correct suspension geometry.
The pad is sold in raw steel, ready for welding and then paint or powder coating. It is designed for Dana 60 axles with a 3 inch diameter axle tube, and welding is required to install it.
Key features
- Laser cut from 1/4 inch steel
- Sold in raw steel, ready for welding
- Ready for paint or powder coating after welding
- Designed for Dana 60 axles with a 3 inch axle tube
- Kit includes one rear bumpstop pad
Preparing the axle for a bumpstop
A bumpstop pad limits how far the axle can travel before the suspension reaches its stop, and its position sets the angle the bump stop contacts the housing. Because the pad is welded to the axle, its location matters as much as its size. Any shift in placement changes how the bumpstop engages, which can add stress to the bracket and the axle tube.
Before welding, clean the mounting area and check the axle tube and any existing brackets for cracks or heavy scale. After welding, look over the joints and allow the steel to cool before painting or powder coating. Regular inspection of the bumpstop contact points helps catch wear early, especially on trails with frequent articulation.
- Clean and inspect the mounting area first
- Check the axle tube for cracks before welding
- Let welds cool before painting
- Inspect bumpstop contact points after heavy use
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 3990060 |
| UPC | 843885002536 |
| Type | Bump stop |
| Material | Steel, 1/4 inch, laser cut |
| Finish | Raw steel |
| Axle compatibility | Dana 60, 3 inch axle tube |
| Quantity | One rear bumpstop pad |
Vehicle fitment
It is for the 2007-2018 Jeep Wrangler JK. It is an axle-specific bracket component, so it is built for that axle setup rather than as a universal part.
Fit is established for the 2007-2018 Jeep Wrangler JK. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Welding is required, so have the pad fitted by someone experienced with axle work. Confirm the axle is a Dana 60 with a 3 inch tube before welding, and allow for paint or powder coating afterward.
What’s included
One rear bumpstop pad.
Not included: Welding equipment and paint or powder coating are needed to finish the pad.









