Overview
The TeraFlex 6 Inch Lift Coil Springs, part number 1854602, are front coil springs for 4-door Jeep Wrangler JK models. They lift the front six inches while removing the factory front rake, and they are a direct fit for the 2007–2015 Jeep Wrangler JK.
The JK Wrangler leaves the factory with its front end sitting about 1.5 inch lower than the rear. TeraFlex designed these springs to eliminate that rake, so after installation the front rises more than the rear and the vehicle levels out. Owners who add winches, bumpers, racks or a larger spare tire should expect the final height to shift. TeraFlex tunes its suspensions to sit near the advertised height with those accessories fitted, so results can vary from one vehicle to another.
Key features
- Designed to remove the factory front rake of the JK Wrangler, which sits about 1.5 inch lower in front than in back
- Front coil springs made for 4-door JK models
- Advertised as a 6 inch lift, with final height depending on added accessories
- Two-door JKs gain about 1 inch more lift than four-door JKs with the same springs
- Built to hold height with aftermarket winches, bumpers, racks and a larger spare tire fitted
- TeraFlex offers leveling spacers to fine-tune JK ride height
Front end setup after lifting
Front springs affect the caster and camber angles, steering geometry and the position of the front axle. Because the front is raised more than the rear on this design, the steering joints work harder. Look over tie rod ends, ball joints and the steering stabilizer before the vehicle is driven on rough ground.
Tires can wear unevenly if the alignment is not set after the change, so rotate and inspect them early. Shock absorbers at the front may need a longer length to match the new height. Check that the front brake hoses and sway bar links still have room at the new height.
- Alignment after the springs are set
- Tie rod ends and ball joints
- Front shock length for the new height
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 1854602 |
| UPC | 843885024033 |
| Lift height | 6 inch |
| Type | Coil springs |
| Body style | 4-door models |
| Vehicle | Jeep Wrangler JK |
Vehicle fitment
The manufacturer fitment list covers the 2007–2015 Jeep Wrangler (JK) with these trims: 70th Anniversary, Rubicon, Sahara, Sport, Unlimited 70th Anniversary, Unlimited Rubicon, Unlimited Sahara, Unlimited Sport, Unlimited X and X.
Earlier TJ and LJ Wranglers and the later JL generation are not covered. Two-door JKs gain about 1 inch more lift with these springs, so confirm your year, body style and trim before installing.
Installation notes
Lift height depends on the accessories on the vehicle, so measure the result only after the vehicle is fully equipped. Changing front height alters the alignment and driveline angles, so have both checked after the springs are installed.
What’s included
Check the package contents against your installation before starting.
Not included: Leveling spacers, which TeraFlex offers as separate options for adjusting JK ride height.









