Overview
The TeraFlex 1853102 is a front coil spring lift set for 2007–2015 Jeep Wrangler JK models, giving 2.5 inch of lift on 4-door Wranglers and 3 inch on 2-door Wranglers. It is built to cancel the factory front rake, the forward tilt that leaves a stock JK’s front end about 1.5 inch lower than its rear, so the vehicle can sit level once it is lifted.
Because these springs aim for a level stance rather than extra height alone, the front rises more than the rear after installation, which is the intended result. TeraFlex expects owners to add winches, bumpers, racks and a larger spare tire, and those accessories change the measured lift, so the advertised figures are targets rather than guarantees. Two-door JKs gain about 1 inch more than 4-door JKs fitted with the same springs, so buyers who want a specific finished height should measure their own results after the work is complete.
Key features
- Front-position coil springs designed to remove the JK’s factory front rake
- 2.5 inch lift on 4-door models and 3 inch lift on 2-door models
- Works on both 2-door and 4-door Wrangler JK bodies
- Two-door JKs gain roughly 1 inch more lift than 4-door JKs with the same springs
- Direct fit for 2007–2015 Jeep Wrangler JK, including Unlimited versions
- Helps the front end match the rear for a more level stance after lifting
- The brand also sells leveling spacers for fine ride-height adjustment on JK vehicles
- Part number 1853102, UPC 843885023852
Living with a leveled JK
A front lift that aims for a level stance changes more than the height at the bumper. Tire size, bumpers and winches all shift the balance, so the finished stance depends on what sits on the vehicle as well as the springs. Settling the setup first and then measuring gives a truer picture of the result.
Leveling spacers are sometimes used for fine adjustment after the springs are in place, and that approach suits owners who want to tune the height in small steps. Keeping a record of the measurements makes later changes easier to judge.
- Check shock length for the higher front
- Confirm brake line length after the lift
- Account for bumper and winch weight
- Measure again after adding accessories
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 1853102 |
| UPC | 843885023852 |
| Position | Front |
| Body styles | 2-door and 4-door |
| Lift height, 4-door | 2.5 inch |
| Lift height, 2-door | 3 inch |
| Factory front rake addressed | About 1.5 inch |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2007–2015 Jeep Wrangler JK, including the 70th Anniversary, Rubicon, Sahara, Sport and X trims and their Unlimited versions. JK models from 2016 onward and Wranglers from the TJ, LJ and JL generations are outside this fit.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Lift height changes alignment and driveline angles, so have the front end aligned and inspect the driveshaft angles after the springs are installed. Measure ride height on both sides once the vehicle is back on the ground, and compare the result with the advertised 2.5 inch and 3 inch figures. Accessories added later will move those numbers, so take the measurements with the setup you plan to run every day.
What’s included
Check the package contents against your installation before starting. Confirm you have the front position before beginning the install.









