Overview
The TeraFlex 4-inch PRO-LCG suspension lift, part number TER1449474, fits the 2004–2006 Jeep Wrangler (LJ) Unlimited and Unlimited Rubicon and the 1997–2006 Jeep Wrangler (TJ) in the 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X versions. It is a system for off-road use that adds suspension performance with minimal modification.
The PRO system shares many features with the larger TeraFlex system and adds a long-arm upper front suspension that still uses the stock axle bracketry. It gives a low center of gravity with maximum ground clearance, long front upper arms and four-link rear upper geometry.
The rear geometry removes the need for a rear track bar and allows full suspension travel. Adjustable rear anti-squat bracketry allows fine tuning. The kit is designed for 35-inch or larger tires and uses 1.75-inch DOM lower FlexArm tubing for strength.
The system works with engine conversions such as V6 and V8 swaps and is designed to work with aftermarket high pinion axles.
Key features
- Long front upper arms
- Four-link rear upper geometry
- Stock axle bracketry for the front long-arm upper
- Adjustable rear anti-squat bracketry
- 1.75-inch DOM lower FlexArm tubing
- Designed for 35-inch and larger tires
Setting anti-squat and pinion angle
Anti-squat controls how the axle reacts under acceleration, and it changes with the lift and the rear geometry. Adjustable rear anti-squat bracketry lets you tune that angle after the lift is installed, so the axle does not wind up or lift under power. Setting it correctly matters more on long-travel systems than on a basic lift.
High pinion axles and engine swaps change driveline angles, so measure the pinion angle once the system is assembled. Re-check the setup after large tire changes, since heavier tires can shift the axle position and affect how the truck handles on the trail.
- Measure the pinion angle with the truck at ride height
- Inspect FlexArm bushings for wear each season
- Check the bracketry hardware after rough trips
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | TER1449474 |
| Lift kit | 4 inches |
| Lift height range | 4 to 5.5 inches |
| Lower FlexArm tubing | 1.75-inch DOM |
| Rear lift component | Coil spring |
| Rear anti-squat | Adjustable bracketry |
| Tire design | 35 inches or larger |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2004–2006 Jeep Wrangler (LJ) Unlimited and Unlimited Rubicon, and the 1997–2006 Jeep Wrangler (TJ) in the 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X versions.
Wrangler JK and JL models are not on the list, and TJ and LJ years outside 1997–2006 and 2004–2006 are not covered.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The PRO-LCG changes the front and rear suspension geometry, and the adjustable rear anti-squat bracketry needs to be set during installation. Check the pinion angle and driveline angles afterward, especially with a high pinion axle.
What’s included
The package covers the long-arm upper front suspension, the four-link rear upper geometry, the 1.75-inch DOM lower FlexArm tubing and the adjustable rear anti-squat bracketry.










