Overview
The Rubicon Express RE7504T is a 4.5-inch Extreme-Duty long arm lift kit with a rear Tri-Link and twin tube shocks, made for the 1997–2002 Jeep Wrangler TJ. The lift falls within the 3 to 4.99-inch range, and the shocks come with the kit.
The long arm design replaces the stock suspension arms with longer control arms, which improves geometry on a lifted vehicle. It gives a more stable, lower-roll ride than a short arm system, with better traction on the trail.
The rear Tri-Link takes the place of the track bar. Because the axle is located by the link instead of a side bar, the wheel can travel straight up and down. Rubicon Express adds that the link increases anti-squat on steep climbs and tracks better on the road.
Key features
- Chromoly long arms built from 4130 chromoly tubing
- Rear Tri-Link that replaces the rear track bar
- Builder Ball misalignment joint, rated by Rubicon Express for up to 32 degrees
- Adjustable control arms with serviceable Super-Flex spherical ball joints
- PT-Meg Super-Ride bushings
- Twin tube shocks included
- Tuned lift springs and stainless steel brake lines
Shocks and long arm geometry
Shocks on a long arm system work through a different range of motion, since the arms swing on a longer radius. Twin tube shocks are a common choice for daily driving on a lifted TJ and suit mixed pavement and trail use. Shock length and mounting angle should match the new arm position, so check the shock’s extension at full droop before buying replacements.
Long arm owners often replace bump stops and bushings at the same time as the shocks. Look for seepage at the shock body, a bouncing ride and loose mounts after trail runs. Tightening the mounting hardware and checking the shock eyelets during routine service keeps the suspension working as designed.
- Check shock extension at full droop
- Inspect shock eyelets and bushings
- Replace shocks in pairs on each axle
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE7504T |
| UPC | 614901453232 |
| Lift height range | 3 to 4.99 inches |
| Suspension type | Long arm |
| Kit type | Extreme-Duty long arm |
| Rear lift method | 3-link (Tri-Link) |
| Control arm material | 4130 chromoly, .250 wall |
| Misalignment joint | Builder Ball, up to 32 degrees, 3 inch OD housing |
| Belly pan | Three-piece, for transfer case and transmission access |
| Shocks included | Yes, twin tube |
| Fitment | Direct fit |
Vehicle fitment
It fits the 1997–2002 Jeep Wrangler (TJ), including the SE, Sahara and Sport models.
Confirm your vehicle’s year, model and trim before ordering, including whether it is a 2003–2006 TJ, JK or YJ.
Installation notes
A long arm conversion changes the alignment and driveline angles, so both need checking once the kit is installed. It is bolt-on for factory Dana 35 and Dana 44 rear axles.
What’s included
The kit includes long control arms, the rear Tri-Link, the Builder Ball, PT-Meg Super-Ride bushings, tuned lift springs, stainless steel brake lines, twin tube shocks and a three-piece belly pan.







