Overview
The SPOD 900-FJ Switch Panel is a pre-wired switch panel for the 2007 to 2013 Toyota FJ Cruiser. It arrives with six dual 24v LED Contura rocker switches installed and wired, plus a 12 position terminal block for accessory attachment.
The switches arrive installed and pre-wired. Some cutting and drilling is still needed to fit the panel, so confirm the mounting location and clearance before starting. It fits the 2007 to 2013 Toyota FJ Cruiser.
Key features
- Six dual 24v LED Contura rocker switches, installed and pre-wired
- 12 position terminal block for accessory attachment
- 8 gauge power leads with crimped and soldered terminals for battery connection
- Six ATO style fuses, three 15 amp and three 30 amp
- Arrives ready with no extra wiring required
- Braided nylon sleeving resists heat and abrasion on the wires
Switch wiring and fuse care
Pre-wired switch panels save time, but the harness still needs a careful look before power goes on. Check that the 8 gauge power leads reach the battery terminal without stretching, and that each crimp is seated and each solder joint looks clean. Route the leads through the sleeving and keep them away from heat sources and sharp body edges.
Fuses protect the wiring, not the switch. Keep spare fuses of the same ratings in the vehicle, and replace a blown one only after finding the cause. When you add accessories to the terminal block, confirm each one draws within the fuse rating for its circuit, and recheck the connections once the vehicle has been driven over rough ground.
- Check crimps and solder joints before connecting power
- Carry spare fuses of the same rating
- Inspect the sleeving after rough trail use
Specifications
| Brand | SPOD |
|---|---|
| Part number | 900-FJ |
| UPC | 70000705537 |
| Switches | Six dual 24v LED Contura rocker, pre-wired |
| Terminal block | 12 position |
| Power leads | 8 gauge, crimped and soldered |
| Fuses | 6 ATO style, three 15 amp, three 30 amp |
| Sleeving | High temp abrasion resistant nylon braid |
| Fitment | 2007 to 2013 Toyota FJ Cruiser |
Vehicle fitment
It fits the 2007 to 2013 Toyota FJ Cruiser.
Other Toyota models, and FJ Cruiser years outside 2007 to 2013, are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Some cutting and drilling is required, so confirm the mounting location and clearance before starting. Disconnect the battery before attaching the 8 gauge power leads.
What’s included
Six dual 24v LED Contura rocker switches installed and pre-wired, a 12 position terminal block, 8 gauge power leads, and six ATO style fuses (three 15 amp and three 30 amp) supplied.
















