Overview
It is a non-CV U-joint front drive shaft for 4WD Jeep Wrangler JK models with lifts. It fits the 2007–2016 and 2018 Jeep Wrangler (JK), including the Rubicon, Sahara, Sport and Unlimited trims.
It is intended for lifts of 0 to 4 inches on 2-door and 4-door models. It is aimed at 2007 and 2008 JK 4WD vehicles with 2 inches or more of lift, where driveline angles increase. It allows 4WD operation above 25 mph and uses exclusive yokes rather than flange adapters, which allows a longer driveshaft.
Key features
- Non-CV U-joint style front drive shaft
- Replaces the factory ball and cage joint with 1310 style U-joints
- Exclusive yokes instead of flange adapters
- Constructed from 2.00 inch by 0.120 inch DOM steel tube
- Kit includes the mounting hardware
Front driveline and steering
A front driveshaft carries power from the transfer case to the front axle when the vehicle is in 4WD. Because the front axle also steers, the shaft must allow for wheel movement at each joint. A non-CV joint style uses U-joints, which handle angle well but need regular attention to stay smooth.
When a front shaft is changed, check the joint at each end for play and confirm the yokes slide and rotate freely. Look at the axle seals and steering components for disturbance after the job. Driving with a worn front driveshaft can cause vibration in the steering wheel, so address it quickly.
- Check U-joints for play at each end
- Confirm yokes move and rotate freely
- Inspect axle seals for leaks after the job
- Watch for steering wheel vibration on the road
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 55827B |
| UPC | 614901126785 |
| Length | Extended |
| Joint type | Non-CV |
| Tube | 2.00 inch by 0.120 inch DOM steel |
| Position | Front |
| Lift range | 0 to 4 inches |
| Slip yoke eliminator | Not required |
| Fitment type | Universal fit |
Vehicle fitment
It fits the 2007–2016 and 2018 Jeep Wrangler (JK), including the 75th Anniversary, Rubicon, Sahara, Sport, Sport S, Unlimited 70th Anniversary, Unlimited 75th Anniversary, Unlimited Rubicon, Unlimited Sahara, Unlimited Sport, Unlimited Sport S and Unlimited X models.
It does not fit the Wrangler TJ, LJ or JL. Joint size is either 1310 or 1314 style, so check it against the factory shaft. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit includes its mounting hardware. Confirm whether your factory shaft uses 1310 or 1314 style joints before installing.
What’s included
The drive shaft and mounting hardware for the front position are included.








