Overview
The Omix-ADA 16590.24 is a front drive shaft built as a direct OE replacement for Jeep applications with a 4.0L 6 cylinder engine and a manual transmission. It has the same length as the factory drive shaft for that application, at 40 in. extended and 37 in. collapsed.
It is a Non-CV shaft at stock length. It is built to the original factory specifications and carries a limited five year warranty.
Key features
- Same length as the factory drive shaft for the same application
- Extends to 40 in. and collapses to 37 in.
- Non-CV design at stock length
- Does not require a slip yoke eliminator
- Limited five year warranty
Front shaft length and setup
A front drive shaft has to match the distance between the transfer case and the front axle, both at full extension and when collapsed. If the shaft is too long it can bind at full droop, and if it is too short the slip yoke can run out of engagement. Checking the collapsed and extended lengths of the old shaft is the most reliable way to confirm a match.
Driveline angle also matters after any lift or change in ride height, because the joints work harder when the angles are off. A shaft that is correct in length still needs the joints and yokes in good condition to run smoothly. Look at the old shaft for bent tubes or worn yokes before fitting a replacement.
- Measure collapsed and extended length of the old shaft
- Check the transfer case and axle angles after a lift
- Inspect the slip yoke for wear
- Check slip yoke engagement after installation
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 16590.24 |
| UPC | 804314138622 |
| Engine | 4.0L 6 cylinder |
| Transmission | Manual |
| Extended length | 40 in. |
| Collapsed length | 37 in. |
| Joint type | Non-CV |
| Length type | Stock |
| Position | Front |
| Slip yoke eliminator | Not required |
| Warranty | Limited five year warranty |
Vehicle fitment
Fit is for 4.0L 6 cylinder engines with a manual transmission. Confirm your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Measure your current shaft collapsed and extended and compare those figures with 37 in. and 40 in> before ordering. A drive shaft should be installed by a qualified technician.
What’s included
This entry covers the front drive shaft only.






