Overview
The Dana Spicer 211121X is a drive shaft seal that fits a 1.375-inch slip yoke. It is a factory replacement part for drive shafts with 1310, 1330 and 1350 u-joint sizes.
Drive shaft seals help keep lubricant in the slip yoke area and out dirt, so the yoke size and u-joint size should match your driveshaft before fitting. Dana Spicer part number 211121X is the reference to use when comparing against an existing seal.
Replacing a slip yoke seal
A slip yoke seal works with the yoke and the sliding splines to keep lubricant in and contaminants out. Because the yoke slides in and out as the driveline flexes, the seal lip is always under some wear. Inspect the yoke surface for grooves or pitting, since a damaged surface will wear a new seal quickly.
Seals are often replaced when the driveshaft is pulled for other work, such as u-joint service. Clean the seal bore, check it for burrs, and install the seal square so the lip is not folded. Refill the lubricant as needed and keep the yoke clean before reassembly.
- Inspect the yoke surface for grooves
- Clean the seal bore before installing
- Install the seal square to avoid a folded lip
- Replace the seal when the driveshaft is pulled
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 211121X |
| UPC | 700008015171 |
| Type | Drive shaft seal |
| Slip yoke size | 1.375-inch |
| U-joint sizes | 1310, 1330 and 1350 |
Vehicle fitment
Match the 1.375-inch slip yoke and the 1310, 1330 or 1350 u-joint size on your driveshaft. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
The drive shaft seal described by the title. No other parts are named.







