Overview
The Rubicon Express JT7134E is a 2-inch leveling kit for the 2020–2026 Jeep Gladiator (JT). It uses steel coil spacers, front shock extensions, sway bar drops and bump stop extensions, so the factory springs and dampers stay in place while the ride height rises.
The kit makes room for 315-tall tires on Sport models and up to 37-inch tires on Rubicon models. It is an economy suspension kit.
Each part does a specific job. Steel coil spacers add height above the factory rear springs. Front shock extensions let the factory dampers reach the higher ride height. Sway bar drops keep the sway bar working at the raised height, and bump stop extensions give the suspension more travel before the bump stops engage.
The kit does not include shocks, so the factory units stay in service with their extensions. Because the factory springs and dampers are kept, this is a lower-cost route than a full suspension system, which Rubicon Express describes as an economy kit.
Key features
- Steel coil spacers at the rear
- Front shock extensions
- Sway bar drops
- Bump stop extensions
- Keeps the factory springs and dampers
- Room for 315-tall tires on Sport and up to 37-inch tires on Rubicon
Before you lift
A leveling kit raises the front and rear by a small amount without replacing the springs or dampers. Because the factory parts stay in place, the new ride height depends on how the stock components were worn, so the change may look uneven if one side has sagged more than the other. Before buying, check the condition of the factory shocks, bushings and bump stops, since aged parts are often replaced alongside a kit like this.
Once installed, pay attention to how the front axle reacts to bumps and how the steering feels at speed. Re-check the bolts on the shock extensions and sway bar drops after the first few trail runs, and look for any contact between the tires and the fender liners at full articulation.
- Inspect factory shocks and mounts before installing
- Recheck fasteners after the first trail outings
- Look for tire rub at full turns and articulation
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | JT7134E |
| Lift | 2 inches |
| Rear lift method | Steel coil spacers |
| Front shock extensions | Included |
| Shocks | Not included |
| Suspension type | Economy kit |
| Tire size | 35 inches |
Vehicle fitment
It fits 2020–2026 Jeep Gladiator (JT) models. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the kit raises ride height, check driveline angles and alignment after installation.
What’s included
Steel coil spacers, front shock extensions, sway bar drops and bump stop extensions.
Not included: shocks.


























